1994 MAZDA MX-5 dimensions

ii DIMENSIONS INTERIOR STRAIGHT-LINE DIMENSIONS (FRONT) Measured location I I @ I @ 1 8 1 Dimensions mm (in) I346 (52.99) 1089 (42.87) 1 158 (45.59) 1034 (40.71) Gartner Banana

INTERIOR STRAIGHT-LINE DIMENSIONS (REAR) - Measured location Dimensions mm (in) Measured location Dimensions mm (in) 0 1130 (44.49) (3 680 (26.77) 0 1390 (54.72) 0 662 (26.06) 0 1424 (56.06) @ 1346 (52.99) d u/ 0 690 (27.17) 0 752 (29.61) Gartner Banana

- DIMENSIONS REAR BODY STRAIGHT-LINE DIMENSIONS Measured location Dimensions mm (in) Measured location Dimensions mm (in) 0 1184 (46.61) 0 31 0 (12.20) 0 472 (18.58) @ 885 (34.84) 0 1044 (41.10) @ 1124 (44.25) 0 625 (24.61) @ 664 (26.14) 0 1213 (47.76) 0 241 (9.49) @ 1035 (40.75) Gartner Banana

L PANEL REPLACEMENT INSTALLATION 0 When installing new parts, measure the dimensions to verify that they are as specified. 37 Gartner Banana

PANEL REPLACEMENT - INSTALLATION When installing new parts, measure the dimensions to verify that they are as specified, and check the fit with associating parts. Plug welding 4 points indicated by (A) are performed during installation of the crossmember. Gartner Banana

PANEL REPLACEMENT INSTALLATION Make plug welding holes in new parts. After temporary installation of new parts, measure the dimensions to verify that they are as specified. Check the fit with associating parts (hood, front fender panel, bumper, etc.). Gartner Banana

PANEL REPLACEMENT - INSTALLATION Make plug welding holes in new parts. After temporary installation of new parts, measure the dimensions to verify that they are as specified. Check the fit with associating parts (hood, front fender, etc.). Plug welding indicated by (A) should be performed from the cabin side. - Gartner Banana

PANEL REPLACEMENT FRONT PILLAR, OUTER COWL SlDE PANEL, HINGE PILLAR, INNER COWL SlDE PANEL AND SlDE SILL PANEL INSTALLATION Make plug welding holes in the outer hinge pillar and the cowl side nusset. After temporary installation of the inner and outer front pillar, outer hinge pillar, and inner cowl side panel, measure the dimensions to verify that they are as specified. Check the fit with as- sociating parts, then weld the points indicated by (A). After welding the points (A), remove the front pillar and the hinge pillar from the body. Then spot weld or plug weld the points indicated by (B). A Gartner Banana