1994 MAZDA MX-5 power steering

Before beginning any service procedure. refer to section T of this manual for I air bag system service warnings and audio antitheft system alarm conditions . STEERING SYSTEM INDEX ....................................... N- 2 OUTLINE ..................................... N- 4 SPECIFICATIONS ........................... N- 4 MANUAL STEERING .......................... N- 4 PREPARATION ............................. N- 4 ................ TROUBLESHOOTING GUIDE N- 5 BOOT ...................................... N- 6 STEERING WHEEL AND COLUMN ........... N- 8 ............. STEERING GEAR AND LINKAGE N-12 ENGINE SPEED SENSING POWER STEERING .......................... N-18 PREPARATION ............................. N-18 TROUBLESHOOTING GUIDE ................ N-20 AIR BLEEDING ............................. N-21 POWER STEERING FLUID ................... N-22 STEERING WHEEL AND COLUMN ........... N-24 STEERING GEAR AND LINKAGE ............. N-25 POWER STEERING OIL PUMP ............... N-33 DRIVE BELT ................................ N-37 25UONX-001 Gartner Banana

INDEX POWER STEERING STEERING WHEEL PLAY: [ 0-30mm (0-1.18 in) ] / DRIVE BELT DEFLECTION I=' I LIMIT: 11.5mm (0.45 in) at 98 N (1 0 kgf, 22 Ibf) 'I =!IS 1. Boot Replacement ................ page N- 6 2. Steering wheel. and column .... On-vehicle inspection pages N- 8,24 Removal / ................... page N- 9 Disassembly / Inspection 1 Assembly .................. page N-10 3. Steering gear and linkage Removal I Installation ......... page N-25 Air bleeding ................. page N-21 Disassembly I Inspection / Assembly .................. page N-26 4. Power steering oil pump ......... Removal / Installation page N-33 ................. Air bleeding page N-21 .......... Power steering fluid page N-22 5. Drive belt ................... Inspection page N-37 .................. Adjustment page N-38 ................ Replacement page N-38 Gartner Banana

N OUTLINEIMANUAL STEERING OUTLINE SPECIFICATIONS Steering wheel Steering shaft and joint d Type Steering gear Outer diameter mm {in) I 370 {I 4.6) I Manual steering Power steering Lock-to-lock turns Shaft ~oinr Power assist 3.36 2-cross joint - I Engine speed sensing Gear Gear ratio 2.8 Rack-and-pinion m (infinite) Rack stroke mm {in} Power steering fluid MANUAL STEERING Collapsible, non-tilt 121 .O i4.76) - I ATF DexronBII or M-111 ~luidca~acit~ L~S qt, Imp qt) I - PREPARATION SST 0.8 (0.85, 0.70) Preload attachment 25UONX-003 Hexagon wrench 49 GO30 797 Handle For removal of tie-rod end 49 1243 785 Installer, boot For measurement of pinion torque For installation of bushing 49 0208 701 A Boot air out tool - For removal and installation of adjusting cover For installation of tie-rod end boot 49 DO32 31 6 Protractor For removal of oil seal For tightening of adjusting cover Gartner Banana

N ENGINE SPEED SENSING POWER STEERING ENGINE SPEED SENSING POWER STEERING PREPARATION SST For removal of tie-rod end For installation of tie-rod end boot 49 01 1 8 850C Puller, ball joint Installer, boot For inspection of power steering fluid pressure For inspection of power steering fluid pressure - --- - - Gauge (Part of 49 1232 670A) Gauge set, power steering For inspection of power steering fluid pressure For inspection of power steering fluid pressure 49 H002 671 Adapter, power steering gauge dP--= &--- Valve body (Part of 49 1232 670A) For removal and installation of upper bearing For pressurize oil seal For removal of backup ring and oil seal For inspection of power steering fluid pressure 49 DO32 306 Support block For removal of upper bearing For pressurize oil seal For removal of backup ring and oil seal 49 DO32 304 Installer, oil seal and bearing Handle / For installtion of oil seal and center bearing 49 DO32 301 Installer body, oil seal and bearing 49 NO32 303 Remover, backup ring and oil seal 49 DO32 31 6 Protractor For removal of oil seal and center bearing For installation of adjusting cover 49 DO32 307 Remover, oil seal and bearing For installtion of oil seal 49 DO32 303 Attachment For installation of center bearing Attachment Gartner Banana

ENGINE SPEED SENSING POWER STEERING N For installation of oil seal 49 NO32 301 Protector body, oil seal For installation of oil seal Guide, oil seal 0 49 NO32 305 Protector, backup ring and oil seal For installtion of steering rack assembly For installation of holder 49 NO32 304 Protector, oil seal 49 DO32 31 3 Seal ring former For formation of seal ring of pinion shaft 49 DO32 315 Former and guide, seal ring For formation of seal ring of control valve 49 DO32 31 0 Protector, pinion shaft For installation of plug assembly For pressurize upper bearing 49 DO32 305 Remover, oil seal and bearing 49 GO32 31 7 Hose For inspection of cylinder sealing For inspection of cylinder sealing For disassembly of oil pump For measurement of pinion torque Preload attachment Holder 49 9200 020 V-ribbed belt tension gauge For measurement of drive belt tention Gartner Banana

N ENGINE SPEED SENSING POWER STEERING TROUBLESHOOTING GUIDE Steering feels heavy - - Poor lubrication, foreign material, or abnormal wear of steering ball joint Stuck or damaged lower arm ball joints lmproper steering pinion preload Damaged steering gear Malfunctioning steering shaft joint Problem I lmproperly adjusted wheel alignment Possible Cause 1 Malfunctioning steering gear lncorrect tire pressure Loose or damaged oil pump drive belt Low fluid level or air in fluid I Leakage of fluid I Insufficient oil pump pressure Steering wheel pulls lncorrect tire pressure to one side Unevenly worn tires ( Weak front spring General instability while driving Worn or damaged stabilizer and/or upper or lower arm bushing Dragging brake Loose lower arm lmproperly adjusted wheel alignment lncorrect tire pressure Damaged or unbalanced wheel Worn or damaged steering joint(s) lmproper steering pinion preload Weak front coil spring Worn or damaged stabilizer and/or upper or lower arm bushing Malfunctioning shock absorber Cracked or worn engine mount Cracked or worn transmission mount Shake (Steering wheel vibrates up/ down) Shimmy (Steering wheel vibrates left1 right) lmproperly adjusted wheel alignment Excessive tire and/or wheel runout Loose lug nuts Unbalanced wheel(s) Excessive steering wheel play Poor steering wheel return Cracked or worn steering gear mount Loose steering gear mounting bolts Stuck or damaged steering ball joint Excessive tire and/or wheel runout Loose lug nuts Unbalanced wheel@) lncorrect tire pressure Unevenly worn tires Malfunctioning shock absorber Loose shock absorber mounting bolts Stuck or damaged lower arm ball joint Cracked or worn suspension bushings Damaged or worn front wheel bearing lmproperly adjusted front wheel alignment Worn steering gear Worn or damaged steering joints Worn or damaged lower arm bushing Loose steering gear mounting bolts Worn linkage or tie-rod ball joint lncorrect tire pressure Stuck or damaged steering joints lmproperly adjusted front wheel alignment lmproper steering pinion preload Ball joint not operating smoothly Steering shaft contacting something Action Lubricate or replace Replace Adjust Replace Replace Adjust Replace Adjust Adjust or replace Add fluid or bleed air Repair or replace Replace Adjust Replace Replace Replace Repair Tighten or replace Adjust Adjust Adjust or replace Replace Adjust Replace Replace Replace Adjust Replace Tighten Adjust or replace Replace Replace Replace Tighten Replace Replace Tighten Adjust or replace Adjust Replace Replace Tighten Replace Replace Replace Adjust Replace Replace Replace Tighten Replace Adjust Replace Adjust Adjust Replace Repair Pagelsection N-25 section R N-32 N-25 N- 9 section R N-25 section Q N-37 N-21,22 - N-34 section Q section Q section R section R section P section R section R section Q section Q N- 9 N-32 section R section R section R section R section Q section Q section Q section B section J N-26 N-25 N-25 section Q section Q section Q section Q section Q section R section R section R section R section M section R N-25 N- 9 section R N-25 N-25 section Q N- 9 section R N-32 N-25 N- 9 Gartner Banana

ENGINE SPEED SENSING POWER STEERING N TROUBLESHOOTING GUIDE (CONT'D) Possible Cause I Problem Abnormal noise from steering system Loose oil pump Loose steering gear Loose oil pump bracket Drive belt loosettight Air in system Malfunctioning steering gear Malfunctioning oil pump Obstruction near steering column or pressure hose Loose steering linkage Worn steering joints Action Tighten Tighten Tighten Adjust Bleed air Replace Replace Repair or replace Tighten or replace Replace PageISection section B N-25 N- 9 N- 9 25UONX41 AIR BLEEDING 1. Check the fluid level. (Refer to page N-22.) 2. Turn the steering wheel fully to the left and right several times with the engine not running. 3. Recheck the fluid level. If it has dropped, add fluid. 4. Repeat steps 2 and 3 until the fluid level stabilizes. 5. Start the engine and let it idle. 6. Turn the steering wheel fully to the left and right several times. 7. Verify that the fluid is not foamy and that the fluid level has not dropped. 8. Add fluid if necessary, and repeat steps 6 and 7. Gartner Banana

ENGINE SPEED SENSING POWER STEERING POWER STEERING FLUID Inspection Fluid level 1. Verify that the fluid level is between the H and L marks. 2. Add the specified power steering fluid if it is below the L mark. Remove the fluid if it is above the H mark. Fluid specification: ATF ~exron~11 or M-111 , I 25UONX-015 Fluid leakage Caution Never hold the steering wheel to the extreme left or right for more than five seconds with the engine running. This could damage the power steering pump. Start the engine and let it idle. Turn the steering wheel fully left and fully right to apply fluid pressure. Inspect the points shown in the figure for fluid leakage. Gartner Banana