Maintenance Schedule
Section A: Scheduled Maintenance Services (Cont.)
&planation of Scheduled
Maintenance Services
?allowing are explanations of the services
isted in Schedule
I and Schedule II.
he proper fluids and lubricants to use are
.isted
in Section D. Make sure whoever
rervices your vehicle uses these. All parts
should be replaced and all necessary
repairs done before you or anyone else
~ives the vehicle.
NOTE: To determine your engine’s
displacement and code, see
“Engine Identification” in the
Index.
ITEM
NO. SERVICE
1 -e Oil and Filter Change* -
Always use SH or SG Energy
Conserving
II oils of proper
viscosity. The
“SH” or “SG”
designation may be shown
alone, or in combination with
others, such as “SHKD,”
“SH,
SG, CD,” “SG/CD,” etc.
* An Emission Control Service.
ITEM
NO. SERVICE
2
3
4
To determine the preferred
viscosity for your vehicle’s
engine (e.g.,
SAE 5W-30 or SAE
10W-30), see “Engine Oil” in
the Index.
Tire Wheel Rotation and
Jnspectioq
- For proper wear and
maximum tire life, rotate your
tires following the instructions
in this manual. See
“Ties,
Inspection and Rotation’’ in the
Index. Check the tires for
uneven wear or damage.
If you
see irregular or premature wear,
check the wheel alignment.
Check for damaged wheels also.
Fan (Water Pump) Drive Belt
Servk
- Inspect and adjust if
necessary at
30,000 mile
(50 000 km), or 30 month
intervals. Replace the belt at
60,000 miles (100 000 km) and
120,000 miles (200 000 km).
-shaft Timin? Belt
Replacemeat”
- Replace every
60,000 miles (100 000 km) and
ITEM NO.
SERVICE
then inspect after 30,000 miles
(50 000 km).
Drain, flush and refill the system
with new or approved recycled
coolant conforming to
GM
Specification 182SM. Keep
coolant at the proper mixture
as
specified. See “Coolant” in the
Index. This provides proper
freeze and boil protection,
corrosion inhibitor level and
maintains proper engine
operating temperature.
Inspect hoses and replace
if
they are cracked, swollen or
deteriorated. Tighten screw-type
hose clamps. Clean the outside
of the radiator and air
conditioning condenser. Wash
the pressure cap and neck.
To help ensure proper operation,
we recommend a pressure test
of
both the cooling system and the
nressure cap.
5 Coolin? Sys&nSemice* -
. . ,214
ProCarManuals.com
