To help ensure proper operation, we recommend a
pressure test of both the cooling system and the
pressure cap.
6. Transaxle Service -- Change both the fluid and filter
every
15,000 miles (25 000 km) if the vehicle is
mainly driven under one or more
of these conditions:
In heavy city traffic where the outside
temperature regularly reaches
90 F (32 C) or
higher.
In hilly or mountainous terrain.
When doing frequent trailer towing.
Uses such as found in taxi, police car or delivery
service.
If you do not use your vehicle under any of these
conditions, change both the fluid and filter every
100,000 miles (1 60 000 km).
7.
8.
9.
Spark Plug Replacement* -- Replace spark plugs
with the proper type. See “Specifications Chart” in
the Index.
Spark Plug Wire Inspection*? -- Inspect for burns,
cracks
or other damage. Check the boot fit at the
distributor and at the spark plugs. Replace wires as
needed.
Air Cleaner Filter Replacement* -- Replace every
30,000 miles (50 000 km) or more often under dusty
conditions. Ask your dealer for the proper
replacement intervals for your driving conditions.
10. Fuel Tank, Cap and Lines Inspection*? -- Inspect
fuel tank, cap and lines (including fuel rails and
injection assembly,
if equipped) for damage or leaks.
Inspect fuel cap gasket for an even filler neck
imprint or any damage. Replace parts as needed.
Periodic replacement of the fuel filter is not required.
* An Emission Control Service.
The
U.S. Environmental Protection Agency or the California Air Resources Board has determined that the failure to perform this maintenance item will not nullify the
emission warranty or limit recall liability prior to the completion of vehicle useful life. General Motors, however, urges that all recommended maintenance services be
performed at the indicated intervals and the maintenance be recorded in “Section E:Maintenance Record”. s
ProCarManuals.com
CHECKOR SERVICE I
WHAT TO DO
Underbody At least every spring, use plain water to
Flushing flush any corrosive materials from the
underbody. Take care
to clean
thoroughly any areas where mud and
other debris can collect.
Section C: Periodic Maintenance
Inspections
Listed below are inspections and services which should
be performed
at least twice a year (for instance, each
spring and fall).
You should let your GM dealer’s
service department or other qualified service center do
these jobs. Make sure any necessary repairs are
completed at once.
.
INSPECTION
OR SERVICE
Restraint Systems
Steering,
Suspension and
Front-Wheel-
Drive Axle Boot
md Seal
Inspection
WHAT SHQULD BE DONE
Now and then, make sure all your belts,
buckles, latch plates, retractors,
anchorages and reminder systems are
working properly. Look for any loose
parts or damage. If you see anything
that might keep a restraint system from
doing its jobs, have
it repaired
Inspect the front and rear suspension
and steering system for damaged, loose
or missing parts, signs of wear, or lack
of lubrication. Inspect the power
steering lines and hoses for proper
hookup, binding, leaks, cracks,
chafing, etc. Clean and then inspect the
drive axle boot seals for damage, tears
or leakage. Replace seals
if necessary.
277
ProCarManuals.com
