1994 BUICK CENTURY lock

0 Move the lever up as far as it will go.
3. Move the ignition key to “Lock.”
4. Remove the key and take it with you. If you can
walk away from your vehicle with the ignition key in
your hand, your vehicle is in
“P’, (Park).
Leaving Your Vehicle With the Engine
Running
If you have to leave your vehicle with the engine
running, be sure your vehicle
is in “P’, (Park) and your
‘parking brake is firmly set before you leave it. After
you’ve moved the shift lever into the
“P,’ (Park)
position, hold the regular brake pedal down. Then, see if
you can move the shift lever away
from “P” (Park)
without first pulling it toward you. If you can, it means
that the shift lever wasn’t fully locked into “P” (Park).
ProCarManuals.com

Torque Lock
If you are parking on a hill and you don’t shift your
transaxle into
“P’ (Park) properly, the weight of the
vehicle may put too much force on the parking pawl
in
the transaxle. You may find it difficult to pull the shift
lever out
of “P’ (Park). This is called “torque lock.” To
prevent torque lock, set the parking brake and then shift
into “P” (Park) properly before
you leave the driver’s
seat.
To find out how, see “Shifting Into ‘P’ (Park)” in
the Index.
When you are ready
to drive, move the shift lever out of
“P’ (Park) BEFORE you release the parking brake.
If “torque lock” does occur, you may need to have
another vehicle push yours a little uphill to take some
of
the pressure from the transaxle, so you can pull the shift
lever out of “P” (Park).
Parking Over Things That Burn
85
ProCarManuals.com

Wagon Rear Vent Windows (Option)
To open, pull the latch forward, then push on the center
of the latch to swing the window out into the open
position.
To close the window, pull the center of the latch and
then press the latch into the closed position.
Horn
You can sound the horn by pressing the horn symbol on
your steering wheel.
Tilt Wheel
A tilt steering wheel allows
you to adjust the steering
wheel before
you drive.
You can also raise it to the highest level to give y6ur
legs more room when you exit and enter the vehicle.
To tilt the wheel, hold the steering wheel and pull the
lever. Move the steering wheel
to a comfortable level,
then release the lever to lock the wheel in place.
88
ProCarManuals.com

You can set the wiper speed for a long or short delay
between wipes. This can be very useful in light rain
or
snow. Turn the band to choose the delay time. The
closer to
“LO,” the shorter the delay.
For steady wiping at low speed, turn the band away
from you
to the “LO” position. For high speed wiping,
turn the band further, to “HI.”
To stop the wipers, move
the band to
“OFF.”
Remember that damaged wiper blades may prevent you
from seeing well enough to drive safely. To avoid
damage, be sure
to clear ice and snow from the wiper
blades before using them. If they’re frozen to the
windshield, carefully loosen or thaw them.
If your
blades do become damaged, get new blades
or blade
inserts.
Heavy snow or ice can overload your wiper motor.
A
circuit breaker will stop the motor until it cools. Clear
away snow or ice to prevent an overload.
Windshield Washer
At the top of the turn signalheadlight beam lever there’s
a paddle with the word “PUSH” on it.
To spray washer
fluid on the windshield, push the paddle.
If you push the paddle less than one second, washer
fluid will spray three
to four times while the wiper
blades
cycle. If you push the paddle longer than one
second, washer fluid will spray as long
as the paddle is
held. When
you release the paddle, the wiper blades will
cycle three to four more times to clear the window and
then either stop or return to your preset speed.
Driving without washer fluid can be dangerous.
A bad
mud splash can
block your vision. You could hit another
vehicle or go off the road. Check your washer fluid level
often.
92
ProCarManuals.com

Of course, you may still turn on the headlights any time
you need to.
To idle your vehicle with the DRL off, set the parking
brake while the ignition
is in the “Off’ or “Lock”
position. Then start the vehicle. The
DRL will stay off
until you release the parking brake.
Press the switch to turn the
map light on and off.
Front Seat Reading Lights (Option)
.. . , ..
L
Press the switch to turn the front seat reading lights on
or off.
100
ProCarManuals.com

Interior Lights Delay
When you pull on the driver’s outside door handle, the
dome and courtesy lights will go on and stay on for
about
40 seconds, or until you turn the ignition on.
If you pull on the driver’s inside door handle within 30
seconds of switching off the ignition, the interior lights
will go
on and stay on for about 5 seconds, to allow you
to unlock your door(s).
Courtesy Lights
When any door is opened, several lights go on. These
lights are under
the instrument panel. Optional lights are
on the rear doors. They make it easy for you to enter and
leave
the vehicle. You also can turn these lights on by
rotating the interior lights switch to
“HI.”
Mirrors
Inside Mirror
When you are sitting in a comfortable driving position,
adjust the mirror
so you can see clearly behind you car.
The day-night adjustment allows
you to reduce glare
from lights behind you, pull the lever toward
you to the
night position.
1 A3
ProCarManuals.com

The armrest can be raised so that a passenger can sit in
the center position.
Rear Locking Storage Compartment
(Wagon)
Use your door key to unlock the storage bin on the
driver’s side near the liftgate.
Ashtrays
Reach under the front edge of the ashtray compartment
to open
it. To remove the ashtray for cleaning, reach
under the ashtray and
push up from behind it.
108
ProCarManuals.com

Brake System Warning Light
BRAKE
If the light comes on while you are driving, pull off the
road and stop carefully. You may notice that the pedal
is
Your Buick’s hydraulic harder to push. Or, the pedal may go closer to the floor.
brake system is divided into It may take longer to stop. If the light is still on, or if the
two parts. If one part isn’t
anti-lock brake system warning light is flashing, have
working, the other part can the vehicle towed for service. (See “Anti-Lock Brake
still work and stop you. For
good braking, though, you
need both parts working
well.
If the warning light comes on, there cou Ild
be a brake
problem. Have your brake system inspected right away. System
Warning Light” and “Towing Your Buick” in the
Index.)
This light should come on as you start the vehicle. If it
doesn’t come on then, have it fixed
so it will be ready to
warn you if there’s a problem.
The brake system warning light will also come on when
you set your parking brake, and it will stay on if your
parking brake doesn’t release fully. If it stays on after
your parking brake is fully released,
it means you have a
brake problem.
113
ProCarManuals.com