N - REMOVE/INSTALL/OVERHAUL
Article Text (p. 2)
1993 Volkswagen Corrado
For Volkswagen Technical Site: http://vw.belcom.ru
Copyright © 1998 Mitchell Repair Information Company, LLC
Wednesday, March 22, 2000 09:21PM
negative battery cable. Remove luggage compartment floor covering and
fuel pump access cover. Disconnect wiring harness and fuel lines from
fuel pump.
2) Using Wrench (3217), loosen fuel pump screw cap. Remove
flange and sealing ring from fuel tank opening. Loosen fuel pump by
twisting it to left. Remove fuel pump from fuel tank.
3) When installing fuel pump, ensure that fuel gauge sending
unit is not bent. Sending unit must be installed with a frontal angle
of 5 degrees. Align mark on flange with fuel tank. To complete
installation, reverse removal procedure.
FUEL PUMP CHECK VALVE
FUEL RAIL & INJECTORS
Removal & Installation (Corrado SLC)
1) Remove ignition wires. Remove hose from mass airflow
sensor. Disconnect hose to fuel evaporative (frequency) solenoid valve
at throttle body.
2) Disconnect throttle position sensor and idle air control
valve. Disconnect accelerator cable from throttle body. Disconnect and
plug coolant hoses at throttle body.
3) Disconnect hose from air intake heated tube. Detach fuel
lines at cylinder head cover and remove from fuel rail. Disconnect
vacuum hose from fuel pressure regulator. Remove upper intake
manifold.
4) With upper intake manifold removed, disconnect wiring
harness from fuel injector(s). Pry off retaining clip(s) from
injector(s). To install injectors, lubricate "O" rings with fuel. To
complete installation, reverse removal procedure.
TORQUE SPECIFICATIONS
TORQUE SPECIFICATIONS (CORRADO SLC)ÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄApplication Ft. Lbs. (N.m)
EGR Temperature Sensor ...................... 15 (20)
Knock Sensors ............................... 18 (25)
Oxygen Sensor ............................... 37 (50)
Throttle Body Bolts ......................... 18 (25)
Upper Intake Manifold Bolts ................. 18 (25)
INCH Lbs. (N.m)
FUEL RAIL BOLTS ............................. 84 (10)
Intake Air Temperature Sensor ............... 84 (10)
ÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄEND OF ARTICLE
