1993 PONTIAC GRAND-PRIX seat adjustment

There are Seven Adjustment Switches:
Power Seat (OPTION)
To Adjust the Six-Way Power Seat:
Front Control
(A): Raise the front of
the seat by holding the switch up. Hold
the switch down to lower the front of
the seat.
Center Control (B): Move the seat
forward or back by holding the control
to the front or back. Raise or lower the
seat by holding the control up or down.
Rear Control (C) : Raise the rear of the
seat by holding the switch up. Hold the
switch down to lower the rear of the
seat.
Adjustable Supports (OPTION)
The adjustable support control allows
you to change the contour
of the driver
and passenger seats. It works
independently of the power seat
control. Adjust your seat for proper
position first, then adjust the contour.
To adjust the driver’s seat, move the
selector switch to
DRIVER. To adjust
the passenger seat, move the selector
switch to
PASS. To lock controls, leave
the selector switch in the middle.
d
Lumbar Supports: Press
the switch forward to
raise the area shown by
the solid arrow. Press the
switch rearward to lower.
Head Support: Press the
switch forward to move
the head restraint
forward. Press rearward
to move it back.
Thigh Supports: Press
the
LT switch forward to
raise the left thigh area.
Press the switch rearward
to lower.
Press the
RT switch
forward to raise the right
thigh area. Press the
switch rearward to lower.
Side Bolster Supports:
Press the switch forward
to narrow the outsides of
the seat. Press the switch
rearward
to widen.
11
ProCarManuals.com

Eight-Way Power Seat With
Adjustable Supports (OPTION)
With this feature, you can adjust the
driver’s seat eight ways:
The seat-shaped controls
(A) adjust the
driver’s seat only. Move the controls in
the direction you want the driver’s seat
to move-up or down, forward or
rearward. In addition, move the
cushion-shaped control to move the
front or rear of the driver’s seat cushion
up or down. Move the seatback-shaped
control to move the driver’s seatback
up
or down.
You can also adjust both the passenger’s I
and the driver’s seat to support your
thighs and back.
Slide the upper right switch to
4 DRIVER or PASS b (Passenger) to
select the seat you want to adjust,
TO
lock controls, leave the selector switch
in the middle.
There are Six Adjustment Switches:
Lumbar Supports:
Press
the switch to raise or
lower the area shown
by
the arrow.
Seatback Recline: Press
the switch to raise or
lower the seatback.
Thigh Supports: Press
the
LT switch to raise or
lower the left thigh area.
Press the
RT switch to
raise
or lower the right
thigh area.
Reclining Front Seatbacks
Lift the lever to release the seatback,
then
tilt the seatback forward or
backward,
as desired. Release the
lever to lock the seatback
in place.
But don’t have a seatback reclined if
your vehicle
is moving.
ProCarManuals.com

Halogen Bulbs
Halogen bulbs have
L b pressurized gas inside and
can burst if you drop or scratch the
bulb. You or others could be injured. Take special care when
handling and disposing of halogen
bulbs.
Checking Aim of the Headlights
@-DOOR MODELS)
Your vehicle has the 55 x 135 mini-
quad headlight system. These
headlights have horizontal and vertical
aim indicators. The aim has been preset
at the factory and should need no
further adjustment.
To check the aim, the vehicle should be
properly prepared as follows:
The vehicle must have all four tires on
a perfectly level surface.
The vehicle should not have any
snow, ice or mud attached to it.
There should not be any cargo or
loading of vehicle, except it should
have a full tank of gas and one person
or
160 pounds (75 kg) on the driver’s
seat.
Tires should be properly inflated.
The horizontal indicator (A) should
read
0 (zero).
ProCarManuals.com

Service lS Appearance C
Checking Aim of the Headlights
(CONT.)
To make sure your headlights are
aimed properly, read all the
instructions before beginning.
Failure to follow these instructlons
could cause damage to headlight
parts.
State inspection stations will allow a
vertical reading of up plus .76 degrees
or down minus
.76 degrees €or the
center of the bubble.
It is recommended that the upper limit
not exceed up plus
.4 degrees for the
center of the bubble. There may be
an
increased chance of being flashed if
adjustment is much above
up plus
.4 degrees.
Aiming HeadJishts
(2-DOOR MODELS)
To check the aim, the vehicle should be
properly prepared as follows:
The vehicle must have all four tires on
a perfectly level surface.
The vehicle should not have any
snow, ice or mud attached to it.
There should not be any cargo or
loading
of vehicle, except it should
have a full tank
of gas and one person
or
160 pounds (75 kg) on the driver’s
seat.
Tires should be properly inflated.
The horizontal indicator should read
0 (zero).
ProCarManuals.com