1993 PONTIAC GRAND-PRIX ignition

Features & Controls
Head-Up Display (CONT.)
To switch the speedometer from
English (conventional) to metric
units, or back again, use the tip of a
ball point pen (or something similar)
to depress the MODE button on the
Driver Information Center until
ENGLISH or METRIC appears on
the display. Release the MODE
button and use the pen to depress the
SET button below it to switch to the
,other unit
of measure.
Care of the Head-Up Display
Clean the inside of the windshield as
needed to remove any dirt or film that
reduces the sharpness or clarity
of the
HUD image.
To Clean the HUD:
Spray household glass cleaner on a soft,
clean cloth. Wipe the HUD lens gently,
then dry it.
Do not spray cleaner
directly on the lens, because the cleaner
fluid could leak inside the unit if you
do.
If You Can’t See the HUD Image
When the Ignition is On:
Is anything covering the HUD unit?
Is the HUD dimmer control close
enough to
HI?
Is the HUD image adjusted to the
proper height?
Still no HUD image? Check the fuse
in the
CLUST position in the fuse
panel. See the
Index under Fuses G
Circuit Breakers.
ProCarManuals.com

Comfort Controls & Audio Systems
Defogging and Defrosting (CONT.)
To rapidly defrost the windshield, slide
the temperature control lever all the
way up and press the (j@ button.
Adjust the fan to the highest speed.
118
Your vehicle is equipped with side
window defogger vents located on the
window pillar. For additional side
window defogging, push the
B/L
button, set the fan control to HI and
aim the side vents on the instrument
panel to the side windows. For
increased air flow to the side vents,
close the center vents.
Rear Window Defogger
The rear window defogger uses a
warming grid to remove fog from the
rear window. Press to turn on. The
defogger will turn off automatically after
about
10 minutes of use. If you turn it
on again, the defogger will operate for
about five minutes only.
You can also
turn the defogger off by turning off the
ignition or pressing the button
again.
Do not attach a temporary vehicle
license across the defogger grid on the
rear window.
ProCarManuals.com

7 SEEK 1
I
12
For the AM/FM Stereo Radio (with or
without Cassette Player):
1. With the radio off or on and the
ignition on, press
SET. The SET
indicator will appear on the digital
screen for five seconds.
2. Within five seconds, press and hold
SEEK A until the correct minute
appears on the display.
3. Press and hold VSEEK until the
correct hour appears on the display.
For the AM/FM Stereo Radio with
Cassette Player
and Equalizer:
1. With the radio off or on and the
ignition on, press
SET. The SET
indicator will appear on the digital
screen
for five seconds.
2. Within five seconds, press and hold
SEEK. untiI the correct minute
appears on the display.
3. Press and hold 4SEEK until the
correct hour appears on the display.
For the AM/FM Stereo Radio with
Compact Disc
Player:
1. With the radio off or on and the
ignition on, press SET. The SET
indicator will appear on the digital
screen for five
seconds.
2. Within five seconds, press and hold
SEEK until the correct minute
appears
on the display.
3. Press and hold TUNE until the
correct hour appears on the
display
121
ProCarManuals.com

Comfort Controls & Audio Systems
I
AM/FM Stereo Radio
The digital display indicates information
on time or radio station frequency, the
AM or EM radio band, whether the
station is
in stereo, and other radio
functions.
PWR-VOL (Power-Volume): Turn
the upper knob to turn the radio
on or
off, or to adjust volume. Press it to
change between the clock and the radio
station frequency display when the
radio is
on. Press the knob to display
the time when the ignition is off.
The control ring behind the
PWR-VOL
knob adjusts the left/right speaker
balance.
TUNE: This knob has two functions.
Turn it to the left or right to tune in
radio stations (the radio station
frequency will be displayed
on the
digital screen). Press this hob to
change between the
AM and FM bands.
The control ring behind the
TUNE
knob adjusts the front/rear speaker
balance.
ProCarManuals.com

Comfo'rt Controls & Audio Systems
AMFM Stereo Radio with
Cassette Player
The digital display indicates information
on time or radio station frequency, the
AM ~k FM radio band, whether the
station
is in stereo, and other radio
functions.
V'OIL-BAL (Volume-Balance): Turn
the upper knob
to turn the radio on or
off, or to change volume. Press it to
change between the clock and the radio
statbn frequency display when the
radio is on. Press the knob to display
the time when the ignition is off.
The control ring behind the VOL-BAL
knob adjusts the lefthight speaker
balance.
TUNE-FADE: This knob has two
functions. Turn it to the left or right to
tune in radio stations (the radio station
frequency will be displayed on the
digital screen). Press this knob to
change between the
AM and FM bands.
The control ring behind the
TUNE
knob adjusts the fronthear speaker
balance.
TREBLE: Slide this lever up to
increase treble, or down to decrease it.
BASS: Slide this lever up to increase
bass, or down to decrease it.
SEEK: When you press SEEKA, you
will tune in the next station higher on
the radio band. When you press
YSEEK, you'll tune in the next station
lower.
When you press
SEEK A and V SEEK
at the same time, the radio will scan
the dial, pausing for a few seconds
at
each station. To select a station, press
both buttons again.
To Preset Radio Stations:
The four pushbuttons can be used to
preset up to
14 radio stations (seven
AM and seven FM).
1. Use the lower knob (TUNE) to tune
in the station you want.
2. Press SET. The SET indicator will
appear
on the digital screen for five
seconds.
3. While the SET indicator is displayed,
press one of the four pushbuttons.
The station you selected will be
automatically tuned whenever you
press this button again.
4. Repeat steps 1-3 for each of four AM
and four FM stations.
ProCarManuals.com

Comfort Controls & Audio Systems
I
.
Player
The digital display indicates information
on time or radio station frequency, the
AM or FM radio band, whether the
station
is in stereo, and other radio
functions.
PWR (Power): Press t'o turn the unit
on and
off when the ignition is on.
VOL (Volume}: Adjusts the volume
up or down, and the bottom of the
digital screen displays the setting.
For a
normal listening level preset at the
factory, press the center of the switch.
128
TUNE: Press this switch to tune in
higher frequencies and lower
frequencies.
SEEK: Press to tune automatically to
the next station higher or lower
on the
band.
BAL (Balance): Adjusts the left/right
and front/rear speaker balance to your
individual taste. When you change
either adjustment, the bottom of the
digital screen will display the point of
balance you have selected. For the
normal setting preset at the factory,
press the left and right or front and rear
buttons at the same time.
AM-FM: Press to select either the AM
or FM radio band. The band you select
will be displayed on the digital screen.
Your radio has an AMAX-certified
receiver. It can produce quality AM
stereo sound and receive C-QuamB
stereo broadcasts. AMAX reduces noise
without reducing the high frequencies
you need for the best sound. You don't
have to do anything to your Delco/GM
radio because AMAX is automatic.
SCAN: Press to listen for a few
seconds to the next station on the AM
or FM band; the scan will continue
every few seconds until you press
SCAN again to stop on a particular
station.
RCL (Recall): Press to change
between the clock and the radio station
frequency displayed on the digital
screen.
ProCarManuals.com

Comfort Controls & Audio Systems
AM/FM Stereo with Compact Disc
Player
(COIVT.)
When Finished with the Compact Disc Player:
If you press PWR or turn off the
ignition, the disc will stay in the player
and start again when you turn on the
ignition or power switch. The disc will
begin playing at the point where it had
been stopped.
ST/PL (Stop/Play): Press to stop the
disc player; the radio will play. Press
again to play the disc (the player will
start playing the disc where it was
stopped earlier).
CD Player Anti-Theft Feature
Delco LOC IP is a security feature that
can be used or ignored. If you ignore it,
the radio will play normally.
If you use
it, your radio cannot be turned on
if it is
stolen. These instructions will tell you
how
to enter a secret code into the
radio. Then,
if battery power is lost for
any reason, the secret code must be
entered again before the radio can be
turned on.
To Set:
1. Write down any 6-digit number and
keep it in a safe place. This is your
secret code.
2. Turn the ignition on.
3. Press the PWR button to turn the
4. Press the PREV and FF buttons at
radio off.
the same time and hold until
You now have only 15 seconds
between each of the following steps.
(6 '' shows on the display. ---
5. Press SET and 000 appears on the
display.
6. Depress SEEK until the first digit of
your code appears.
7. Depress SCAN until the second and
third digits of your code appear.
8. Press AM-FM (000 appears).
9. Depress SEEK until the fourth digit
of your code appears.
10. Depress SCAN until the fifth and
sixth digits of your code appear.
11. Press AM-FM (rEP will appear for
five seconds, then
000).
12. Repeat steps 6 through 10. Then
press the
AM-FM button again.
SEC will appear, indicating that
Delco
LOC IP is set, and your
radio is secure.
If " " appears,
the steps were not successful and
you must repeat the entire
procedure. ---
ProCarManuals.com

To Disable the Anti-Theft System:
Enter your secret code by following
these steps (you will have only
15
seconds between each step).
1. Turn the ignition on and the radio
off, then press the PREV and FF
buttons of the station presets. SEC
will appear, showing the radio is
secure.
2. Press SET and 000 appears on the
display.
3. Depress SEEK until the first digit of
your secret code appears.
4. Depress SCAN until the second and
third digits of your code appear.
5. Press AM-FM (000 will appear on
the display).
6. Depress SEEK until the fourth digit
of your code appears.
7. Depress SCAN until the fifth and
sixth digits
of your code appear.
8. Press AM-FM. If the display shows
will play again. If the display shows
SEC, the steps were not successful
and the numbers did not match the
secret code.
If you lose or forget your code, see your
dealer.
If
you lose battery power, when the
battery
is reconnected, the radio will
not turn on and LOC will appear.
Follow steps 1-8 for disabling your
system, but the time will appear if
you
are successful. If SEC appears, the
numbers did not match and your unit is
still locked.
ii " the radio is unsecured and ---
Steering Wheel Controk for
Audio System (omow
Some audio functions can be operated
with these controls:
4ON/OFFb: Press ON t'o turn the
system
on. Press OFF to turn it off.
TUNE Press an up or down arrow on
TUNE to tune the radio to stations
higher or lower
on the AM or FM band.
STOP PLAY: Press to play the radio
when a cassette is playing. Press again
to play the cassette
when the radio is on.
BAL (Balance): Press +BAL or
BAL) to adjust your speaker balance
to the left or right.
131
I
...
I
ProCarManuals.com