1993 OLDSMOBILE SILHOUETTE buttons

Features & Controls
88
Temperature and Compass
Display
(CONI)
2. Press and hold both the ONlOFF and
the USlMET switches. The display
will
go off.
appear on the display. When it does,
release both buttons.
4. Press USlMET until your zone
number appears on the display.
5. Press ON/OFF to enter your zone
number. Your variance
is now set.
3. After 5 seconds, VAR CAL will
c
Storage Compartment
To open the rear storage compartment in
the overhead console, press the release
button.
i..
I
Sunglasses Storage Compartment
To open the sunglasses storage
compartment
in the overhead console,
press the release button. Then pull
the
compartment down to the full open
position, as shown.
ProCarManuals.com

Comfort Controls & Audio Systems
Setting the Clock
For radios with VSElZKk
1 . With the radio on or off, press SET.
The SET indicator will appear on the
digital display for five seconds. You
must begin to set the clock to
the
correct hour and minute during those
five seconds.
correct hour appears on the display.
correct minute appears on the display.
2. Press and hold VSEEK until the
3. Press and hold SEE- until the For radios with
SEEK and SCAN
buttons:
1. With the radio on or off, press SET.
The SET indicator will appear on the
digital display for five seconds. You
must begin to set the clock to the
correct hour and minute
during those
five seconds.
correct hour appears on
the display.
correct
minute appears on the display.
2. Press and hold SEEK until the
3. Press and hold SCAN until the For radios
with +SEEXP and SCAN:
1. With the radio on or off, press SET.
The SET indicator will appear on the
digital display for five seconds.
You
must begin to set the clock to the
comect hour and minute during those
five seconds.
2. Press and hold SCAN until the
correct hour appears on the display.
3. Press and hold +SEEK or SEEK,
until the correct minute appears on
the display.
ProCarManuals.com

IM.FM Stereo Radio
'he digital display indicates information In time or radio station fi-equency, the AM
Nr FM radio band, whether the station is
n stereo, and other radio functions.
Jpper Knob (VOL): This knob does
mr things:
Turn it to turn the system on and off
(your ignition must be on).
Turn it to control the volume.
the station frequency to the digital
display screen.
1 When the ignition is off, press it to
display the clock.
1 When the radio is on, press it to recall
BAL (Balance): The control ring
behind the upper knob adjusts the
left/right speaker balance.
Lower Knob (TUNE): This knob does
two things
:
Turn it to tune in radio stations.
Press it to change between the AM
and FM bands (the digital screen will
momentarily display AM or
FM, and
indicate
if the radio is in stereo).
FADE: The control ring behind the
lower knob adjusts the fronthear
speaker balance.
VSEEU: Press to seek and stop on
the next station higher or lower on the
radio band.
You can also use the SEEK buttons to
scan radio stations up or down the
AM
or FM bands.
To scan stations up the band, press and
hold
SEE-, then press VSEEK, then
release both buttons. The radio will go
to the next station and pause there for a
few seconds. It will continue to scan
until you press either
SEEK button.
To scan stations down the band, press
and hold
VSEEK, then press SEE-,
then release both buttons. The radio will
go to the next station and pause there for
a few seconds. It will continue to scan
until you press either
SEEK button.
123
ProCarManuals.com

Comfort Controls & Audio Systems
AMIFM Stereo Radio (CONT.)
TREBLE: Slide this lever up to
increase treble, or down to decrease it.
If a station is weak
or noisy, reduce the
treble.
BASS: Slide this lever up to increase
bass, or down to decrease it.
To Preset Radio Stations:
1. Tune in the desired station.
2. Press SET. The word SET will
appear
on the digital screen for five
seconds.
3. While SET is displayed, press one of
the four pushbuttons.
4. Repeat steps 1-3 for each of four AM
and four FM stations. Up to
three additional stations on each
band may be preset by “pairing”
pushbuttons:
1 . Tune in the desired station.
2. Press SET, and within five seconds
press any two adjacent pushbuttons at
the same time.
3. The station can be tuned in when the
same two pushbuttons are pressed
at
the same time.
ProCarManuals.com

IMIFM Stereo with Cassette
'layer
'he digital display indicates information
In time or radio station frequency, the
AM
lr FM radio band, whether the station is
n stereo, and other radio functions.
Jpper Knob (VOL): This knob does
ive things:
Turn it to turn the system on and off
(your ignition must be on).
1 Turn it to control the volume.
1 When the radio is on, press it to recall
the station frequency to the digital
display screen.
1 When the ignition is off, press it to
display the clock.
When a tape is playing, press it to
hear the other side of the tape.
BAL (Balance): The control ring
behind the upper knob adjusts the
lefthght speaker balance.
Lower Knob (TUNE): This knob does
two things:
Turn it to tune in radio stations.
Press it to change between the AM
and FM bands (the digital screen will
momentarily display
AM or FM, and
indicate if the radio is in stereo).
FADE: The control ring behind the
lower knob adjusts the fronthear
speaker balance.
TREBLE: Slide this lever up to
increase treble, or down to decrease it.
If a station is weak
or noisy, reduce the
treble.
BASS: Slide this lever up to increase
bass, or down to decrease it.
V SEEK A: Press to seek and stop on
the next station higher or lower on the
radio band.
You can also use the
SEEK buttons to
scan radio stations up or down the
AM
or FM bands.
To scan stations up the band, press and
hold
SEE-, then press VSEEK, then
release both buttons. The radio will go
to the next station and pause there for a
few seconds. It will continue to scan
until you press either
SEEK button.
To scan stations down the band, press
and hold
VSEEK, then press SEEU,
then release both buttons. The radio will
go to the next station and pause there for
a few seconds.
It will continue to scan
until
you press either SEEK button.
ProCarManuals.com

Comfort Controls & Audio Systems
126
AM/FM Stereo with Cassette
Player (CONT.)
To Preset Radio Stations:
1 . Tune in the desired station.
2. Press SET. The word SET will
appear on the digital screen for five seconds.
3. While SET is displayed, press one of
the four pushbuttons.
4. Repeat steps 1-3 for each of four AM
and four FM stations.
Up to three additional stations on each
band may be preset by "pairing"
pushbuttons:
1. Tune in the desired station.
2. Press SET, and within five seconds
press any two adjacent pushbuttons at the same time.
3. The station can be tuned in when the
same two pushbuttons are pressed at
the same time.
I_".__.
To Play a Cassette Tape:
With the power switch on, insert a tape
into the cassette door.
Do not use tapes
that are longer than
45 minutes on each
side.
When the right indicator arrow is lit,
selections listed on the bottom side of
the cassette are playing. When the left
arrow is lit, selections listed on the
top
side of the cassette are playing. To
change sides of the
tape while the
cassette is playing, press the upper
knob. When the end
of a tape is
reached, the other side will then play.
Fast Forward: Press the button with the
arrow pointing in the same direction that
the tape is playing.
To stop fast forward,
lightly press the
STOP-EJECT button.
Reverse: Press the button with the
arrow pointing
in the opposite direction
that the tape is playing. To stop reverse,
lightly press the
STOP-EJECT button.
STOP-EJECT To stop playing a tape,
fully press this button (the cassette will
be partially ejected, and the radio will
begin playing).
ProCarManuals.com

Comfort Controls & Audio Systems
AM/FM Sfereo with Cassette
Player
with Dolby@ (CONZ)
The five pushbuttons under the cassette
entry door can be used to preset up to 15
radio stations
(five AM, five FM1 and five
FM2). The buttons have other uses when
you are playing a tape (see
To Play a
Cassette Tape later in this section).
To Preset Radio Stations:
1. Tune the digital display to the station
you want.
2. Press SET. The SET indicator will
appear
on the digital screen for five
seconds.
3. While the SET indicator is displayed,
press one
of the five pushbuttons.
4. Repeat steps 1-3 for each of five AM
and five FM stations.
5. Press the lower knob until FM2
appears on the digital display. You
can then follow steps
1-3 for five
more
FM stations.
To Play a Cassette Tape:
Press PWR to turn the radio on. The
radio will play until a cassette is pushed
into the cassette entry door (the tape
side goes
in first). Do not use tapes that
are longer than
90 minutes (45 minutes
on each side).
This audio system has automatic
DOLBY
B NR@ to reduce
background noise on Dolby encoded
tapes. Dolby@ Noise Reduction is manufactured under license from Dolby
Laboratories Licensing Corporation.
Dolby@ and the
EO symbol are
trademarks of Dolby Laboratories
Licensing Corporation.
PROG (Program): Press to change the
side
of tape being played. When the end
of a tape is reached, the other side will
then play.
CrO,: This button sets tape bias. When
playing high bias chrome or metal tapes,
press the button
to turn the CrOz display
on. When playing standard tapes, press
again to turn the display off.
REV (Reverse): Press to reverse the
tape rapidly; lightly press again or
lightly press
PROG to play the tape.
(The radio plays while a tape is rewinding.)
FWD (Fast Forward): Press to advance
the tape rapidly; lightly press again or
lightly press
PROG to play the tape. (The
radio plays while a tape is advancing.)
PREV (Previous): Press PREV to
repeat a passage. The tape will back up
and stop at the first four-second quiet spot in the tape, or when
you press
PREV again or PROG.
NEXT
Press to go to the next selection
on the tape. The tape will stop at the
first four-second quiet spot in the tape,
or if you press
NEXT again or PROG.
ST-PL (Stop-Play): Press to switch from
the tape to the radio. Press again to
resume playing the tape.
EJECT: Press to eject the cassette tape
(the radio will then play). Tapes can be
ejected when the ignition
is off.
ProCarManuals.com

.. .................... .. , ......
~Iz;iiico]
.. .. ............. -----.-...I- ..... ............ ... .~ I
VOL , TUNE PREV NEXT REV FF COMP - _ - -. __ ...... ...... . :. ."/,. I ,=. , .ll?. 7 , - -- .. ..
0 0 . ... ............... .. ......... ..
. .,i.
1 EJCT - ST/PL 0 .____I 0 ~ .I ,$. ..... ...... .._.. .. .......... X306 1
AMIFM Stereo wrth Compact
Disc
Player
The digital display indicates information
on time or radio station frequency, the AM
or
FM radio band, whether the station is
in stereo, and other radio functions.
POWER: Turns the unit on and off
when
the ignition is on.
VOL (Volume): Adjusts the volume up
or down, and the bottom
of the digital
screen displays
the setting. For a normal
listening level preset at the factory, press
the center of the switch.
TUNE: Press the top of the switch to
tune in radio stations higher on the AM or
FM band. Press the bottom to tune in
stations lower on
the band.
BASS: Adjusts the bass level up or
down. The bottom
of the digital screen
will display the level you have selected.
For a normal listening level preset at
th
factory, press the center of the switch. e
TREB (Treble): Adjusts the treble level
up or down. The bottom
of the digital
screen will display the level you have
selected. For a normal listening level
preset at the factory, press the center
of
the switch,
BAL (Balance): Adjusts the lefthight
and fronthear speaker balance to your
individual taste. When you change
either adjustment, the bottom
of the
digital screen will display the point of
balance
you have selected. For the
normal setting preset at the factory,
press the left and right or front and rear
buttons at the same time.
129
ProCarManuals.com