1993 GMC SIERRA tow

2. Don’t push the accelerator pedal before starting your engine.\
In some
other vehicles you might need to do this, but because of your vehicle’s
computer systems, you don’t.
key. The idle speed will go down as your engine gets warm.
3. Turn your ignition key to Start. When the engine starts, let go of the
Holding your key in
Start for longer than 15 seconds at a time will caus
your battery to be drained much sooner. And the :essive heal
m
damage your starter motor.
4.
5.
If it doesn’t start right away, hold your key in Start. If it doesn’t start in
three seconds, push the accelerator pedal about one-quarter of the way
down for
12 more seconds, or until it starts.
If your engine still won’t start (or starts but then stops), \
it could be
flooded with too much gasoline. Try this:
Wait
15 seconds to let the starter motor cool down. Then push your
accelerator pedal all the way to the floor. Hold it there. Then, hold the
key in
Start for no more than ten seconds. This clears the extra
gasoline from the engine.
If the engine still doesn’t start, wait another 15 seconds and do it all again.
When the engine starts, let go of the key and accelerator ped\
al.
Your engine is designed to work with the electronics in your vehicle.
If you
add electrical parts or accessories, you could change the way \
the fuel
injection system operates. Before adding electrical equipment, ch\
eck with
-w dealer. If you don’t, your engine might not perform properly
If you ever have to have your vehicle towed, see the part of th\
is Manua
that tells how to do
it wit‘--.Jt damaging your ?hide. See “Tc ‘ng Yo
Vehicle’’ in the lnde
To Start Your 5.7 Liter (Code K) engine
or 7.4 Liter (Code N) engine:
1. Automatic Transmission
Move your shift lever to P (Park) or N (Neutral). Your engine won’t start
in any other position-that’s a safety feature.
To restart when you’re
already moving,
use N (Neutral) only.
2-1 3
ProCarManuals.com

When the engine starts, let go of the key and accelerator ped\
al. Your engine is designed to work with the electronics in your vehicle.
If you 1
add electrical parts or accessories, you could change the way the fuel
injection system operates. Before adding electrical equipment, ch\
eck with
your dealer. If you don’t, your engine might not perform properly.
If you ever have to have your vehicle towed, see the part of this Manu; .
that tells how to do it without damaging your vehicle. See “Towing Your
Vehicle” in the Index.
NOTICE I
If you -drive too quickly through deep puddles or standing water, water can
come
in through your engine’s air intake and badly damage your engin\
e. 1%-
you can’t avoid deep puddles or standing water, drive through very slowlv. I
--
Never drive through standing water more than 8 inches deep if yo~
vehicle has a diesel engine.
Also, don’t drive through any standing water
faster than
5 mph (8 kmh). If you do, water can be drawn in through the
air intake, and this can severely damage your engine.
-
Driving In Snow (Diesel Engines)
When driving in a heavy snowstorm or in swirling snow with a diesel engine,
snow can get into the air intake system.
If you keep driving in these
conditions, the air cleaner may get plugged, causing black smok\
e and
loss of
power. In an emergency,
if the air cleaner is plugged with snow, you can
remove the air cleaner. Then, drive to a place
of safety as soon as possible
and put the air cleaner back on.
Starting Your Diesel Engine
Your diesel .engine starts differently than a gasoline engine.
1. Automatic Transmission:
Move your shift lever to P (Park) or N (Neutral). Your engine won’t start
in any other position-that’s a safety feature.
To restart when you’re
already moving, use
N (Neutral) only.
2-1 5
ProCarManuals.com

Automatic lLansmission
K2362
There are several different positions for your gear lever.
P (Park)
This locks your rear wheels. It’s the best position to use when you start your
engine because your vehicle can’t move easily.
* It is dangerous to get out of your vehicle if the shift lever is not fully
in
P (Park) with the parking brake firmly set. Your vehicle can roll.
Don’t leave your vehicle when the engine is running unless \
you have
to. If you have left the engine running, the vehicle can move
suddenly. You or others could be injured.
To be sure your vehicle
won’t move, when you’re on fairly level ground, always se\
t your parking brake and move the shift lever to
P (Park).
If you have four-wheel drive, your vehicle will be free to roll-even
if
your shift lever is in P (ParkLif your transfer case is in N (Neutral).
So, be sure the transfer cas s in a drive gear-not N {“eutral).
See “Shifting Into
P- I;’’ in tne 3ex. If you are parking on a hill, or
if you’re pulling a traller, also see “Parking on Hills” \
or “Towing a
Trailer’’ in the Index.
2-2 1
ProCarManuals.com

Featums & Contmls
R (Reverse)
Use this gear to back up.
Shifting
to R (Reverse) while your vehicle is moving forward could damage
your transmission. Shift
to R (Reverse) only after your vehicle is stopped. I
b
1
damaging your transmission, see “If Yo$re Stuck: In Sand, Mud, Ice or
Snow” in the Index.
N (Neutral)
In this position, your engine doesn’t connect with the wheels.
To restart when
you’re already moving, use
N (Neutral) only. Also, use N (Neutral) when your
vehicle is being towed.
CAUTION I
Shifting out of P (Park) or N (Neutral) while your engine is “racing”
(running at high speed) is dangerous. Unless your foot is fi\
rmly on
the brake pedal, your vehicle could move very rapidly. You cou\
ld lose
control and hit people
or objects. Don’t shift out of P (Park) or N
wI ! your enaine is racing.
I
NOTICE
I
1
Damage to your transmission caused by shifting out of P (Park) or N
(Neutral) with the engine racing isn’t covered by your war\
ranty.
OD (Automatic Overdrive)
This position is
for normal driving. If you need more power for passing, and
you’re:
- Going less than about 35 mph (56 km/h), push your accelerator
- Going about 35 mph (56 kmlh) or more, push the accelerator all the
pedal about halfway down
way down
You’ll shift down
to the next gear and have more power.
OD should not be used when towing a trailer, carrying a heavy load, driving
on steep hills,
or for off-road driving. Select D (third gear) when operating the
vehicle under any of these conditions.
2-22
ProCarManuals.com

D (Third Gear)
This is like
OD, but you never go into Overdrive. You should use D when
towing a trailer, carrying a heavy load, driving on steep hills, or for off-road
driving.
2 (Second Gear)
This position gives you more power but lower fuel economy. You can use
2
on hills. It can help control your speed as you go down steep mountain
roads, but then you would also want to use your brakes
off and on.
If you manually select 2, the transmission will drive in second gear. You may
use this feature for reducing torque to the rear wheels when you are trying
to
start your vehicle from a stop on slippery road surfaces.
1 (First Gear)
This position gives you even more power (but lower fuel econo\
my) than
2.
You can use it on very steep hills, or in deep snow or mud. If the selector
lever
is put in 1, the transmission won’t shift into first gear until the vehic\
le is
going slowly enough.
NWTIGE
If your rear wheels can’t rotate, don’t try to drive. This might happen if
you were stuck in very deep sand or mud or were up against a. solid
object. You could damage your transmission.
AWZ , <,*,~l,<.,. ...
Also, if you stop when going uphill, don’t hold your vehic there with only the
accelerator pedal.
This could overheat and damage ,the transmission. Use your
brakes or shii into P (Park) to hdd your vehicle in position on a hill.
.,$*’,,&:&> ._,, , . ~ ~ ,>&:a
2-23
ProCarManuals.com

Parking Brake
K2221
To set the parking brake:
Hold the regular brake pedal down with your right foot. Push down the
parking brake pedal with your left
foot. If the ignition is on, the brake system
warning light will come
on.
To release the parking brake:
Hold the regular brake pedal down. Pull the lever marked RELEASE.
Driving with the parking brake on can cause your rear brakes to overheat.
You may have to replace them, and you also da other p;
of I
your vehicle.
’ ‘
If you are on a hill:
See “Parking on Hills” in the Index. That part shows how to turn your front
wheels.
If you are towing a trailer and are parking on any hill:
See “Towing a Trailer” in the Index. That part shows what to do first to keep
the trailer from moving.
2-29
ProCarManuals.com

Features & Controls
Propshaft Brake Burnish Procedure
If you have a 3500 HD Model, it is recommended that the propshaft mounted
parking brake be burnished as part of the new vehicle break in. The parking
brake
will work best after it has been burnished following these instructions.
Make
10 stops, using the parking brake foot pedal, from 20 mph (32 k\
m/h)
about 2
112 miles (4 km) apart. In between stops, drive the vehicle at 20
mph (32 kmlh).
Torque Lock
The parking brake should be set first whenever leaving the dri\
ver’s seat. If
you are parked on a hill and the transmission is placed in P (Park) before
the parking brake is set, the weight of the vehicle may put too much force
on the parking pawl in the transmission.
It may be difficult to pull the selector
lever out of
P (Park). This is called “torque lock.” To prevent this, the parking
brake should be set
BEFORE moving the selector lever to P (Park).
When preparing
to move the vehicle, the selector lever should be moved out
of
P (Park) BEFORE releasing the parking brake. Set the parking brake first,
then release the transmission from
P (Park), even on level surfaces.
If “torque lock” does occur, you may have to have another vehicle nudge
your vehicle uphill a little
to take some of the pressure off the transmission
while you pull the selector lever out of
P (Park).
Shifting Into P (Park) (Automatic Transmission Models Only)
1 CAUTION
It can be dangerous to get out of your vehicle if the shift lever is not
fully in
P (Park) with the parking brake firmly set. Your vehicle can
roll.
If you have left the engine running, the vehicle can move suddenly.
You
or others could be injured. TO be sure your vehicle won’t move,
when you’re
on fairly level ground, use the steps that follow.
If you have four-wheel drive and your transfer case is in N (Neutral),
your vehicle will be free to roll-even if your shift lever is in P
{Park). So, be sure the transfer case is in a drive gear-not N
(Neutral).
If you are parking on a hill, or if you’re pulling a trailer, also see
“Parking on Hills9’ or “Towing a Trailer” in the Index. I
2-30
ProCarManuals.com

Steering Column Shift Lever
1. Hold the brake pedal down with your right foot and set the parking
brake.
2. Move the shift lever into the P (Park) position like this:
Pull the lever toward you.
~- - --
w KL" I"
Move the lever up as far as it will go.
3. If you have four-wheel drive, be sure the transfer case is in a drive
4. Move the ignition key to LOCK.
5. Remove the key and take it with you. If you can walk away from your
vehicle with the ignition key
in your hand, your vehicle is in P (Park).
gear-not
in N (Neutral).
2-31
ProCarManuals.com