Page 10 of 339
How to Use this Manual
Vehicle Symbols
These are some of the symbols you will
find on your vehicle. For example, these
symbols are used
on an original battery:
Caution Possible injury
Protect Eyes by Shielding
Caustic Battery Acid
Could Cause Burns
Avoid Sparks or Flames
Sparks
or Flame Could
Explode Battery
These symbols are important for you
and your passengers whenever your
vehicle
is driven:
Fasten Safety Belts
i
These symbols have to do with your
lights:
Master Lighting Switch
Turn Signal Direction
Hazard Warning Flasher
A
Headlight High Beam
Headlight
Low Beam
Parking Lights
Brightness Control
5a ytime Running Lights
(Canada)
ProCarManuals.com
Page 12 of 339
How to Use this Manual
These symbols are used on warning and
indicator lights:
Engine Coolant
Temperature
Battery Charging System
Fuel
I.. 10
E3
Brake
w
Here are some other symbols you may
see:
Hood Release
Lighter
Horn
ProCarManuals.com
Page 52 of 339
Features & Controls
... 50
3. If it doesn't start right away, hold
your
key in START for about three
seconds at a time until your engine
starts. Wait about
15 seconds
between each try to help avoid
draining your battery.
Holding your key in
START for
longer than
15 seconds at a time
will cause your battery
to be
drained much sooner. And the
excessive heat
can ~ag~~~ gz <&!Kg::, starter motor. p-,'*'Q,&P'F$+
If your engine still won't start, call your
dealer for help.
IVU I lLt
I Driving through Deep
Standing Water
ProCarManuals.com
Page 87 of 339

Engine Coolant Temperature Gage
This gage shows the engine coolant
temperature. If the gage pointer moves
to the “H” (red) side, your engine is
too hot! It means that your engine
coolant has overheated and you should
stop your vehicle and turn off the engine
as soon as possible.
HOT
COOLANT CAN BURN YOU
BADLY!
In “Problems on the Road, ” this
manual shows what to do. See “Engine
Overheating’’
in the Index.
-I
I L
Charging System Light
This light will come on briefly when
you turn on
the ignition, but the engine
is not running, as a check to show you it
is working. Then it should go out when
the engine starts. If it stays on, or
comes on while you are driving, you
may
have a problem with the electrical
charging system. It could indicate that
you have a loose generator drive belt, or
another electrical problem. Have
it
checked right away. Driving while this
light
is on could drain your battery.
If you must drive a short distance with
the light
on, be certain to turn off
all your accessories, such as the radio
and air conditioner.
Malfunction Indicator Lamp (Check
Engine Light)
A computer monitors operation of your
fuel, ignition and emission control
systems. The light should come on when
the ignition is on, but the engine is not
running, as a check to show you
it is
working. If
it does not come on at all,
have it fixed right away. If it stays
on,
or comes on while you are driving, the
computer is indicating that you have
a
problem. You should take your vehicle
in for service soon.
85.9.
ProCarManuals.com
Page 115 of 339

EJECT
Press A to remove the tape or stop
the tape and switch to radio.
Radio Monitor
Press the RADIO MNTR button to hear
the radio when you are fast forwarding
or reversing a cassette tape.
You can use
the TUNE, SEEK and PRESET SCAN
buttons while in the radio monitor
mode.
Theft-Deterrent Feature
The theft-deterrent feature for the
AM/FM stereo with cassette tape player
can be used or ignored. If ignored,
the
system plays normally. If it is used,
your system won’t be usable
if it’s ever
l stolen.
Setting Your Security Code
The instructions below tell you how to
enter a security code into the system. If
your
vehicle loses battery power for any
reason, you must enter
the security code
again before the system will turn on.
1. Write down any four-digit number
2. Turn the ignition switch to the ACC
3. Turn the audio system off.
4. Press the 1 and 4 buttons together.
and keep it in
a safe place.
or
ON position.
Hold them down until
“-L” shows
on the display.
You are now ready to enter your
security code. Don’t wait more than
15
seconds between steps.
5. Press 4SEEKb and/or 4TUNEb
and “OOOO” will appear on the
display.
6. Press SEEK4 and hold it until the
first digit of your code appears.
Release the button.
7. Press SEEK, and hold it until the
second digit of your code appears.
Release the button.
8. Press TUNE4 and hold it until the
third digit of your code appears.
Release the button.
113. 9
ProCarManuals.com
Page 178 of 339

Your Driving and the Road
.._
176
If you have no blankets or extra
clothing, make body insulators from
newspapers, burlap bags, rags, floor
mats
- anything you can wrap around
yourself or tuck under your clothing to
keep warm.
You can run the engine to keep warm,
but be careful.
A
Snow can trap exhaust gases
under your vehicle. This can
cause deadly
CO (carbon
monoxide) gas to get inside.
CO
could overcome you and kill you.
You can't see it or smell it,
so you
might not know it was in your
vehicle. Clear away snow from around the base
of your vehicle,
especially any that is blocking your
exhaust pipe. And check around
again from time to time to be sure
snow doesn't collect there.
Open a window just a little on
the
side of the vehicle that's away
from the wind. This will help keep
co out. Run your engine only as long as you
must. This saves fuel. When
you run the
engine, make it go a little faster than
just idle. That is, push the accelerator
slightly. This uses less fuel for the heat
that you get and it keeps the battery
charged. You will
need a well-charged
battery to restart the vehicle, and
possibly for signaling later on with your
headlights.
Let the heater run for
awhile.
Then, shut the engine off and close the
window almost all the way to preserve
the heat.
Start the engine again and
repeat this only when you feel really
uncomfortable from the cold. But do it
as little as possible. Preserve the fuel as
ProCarManuals.com
Page 193 of 339
Jump Startirtg
If your battery has run down, you may
want to use another vehicle and
some
jumper cables to start your Geo. But
please follow the steps below to do it
safely. Batteries
can hurt you.
They
L can be dangerous because:
0 They contain acid that can burn
They contain gas that can
They contain enough electricity
If you don't follow these steps
exactly, some or
all of these thin
can hurt you.
you.
explode or ignite.
to burn you. Ignoring these steps could result in
costly
damage to your vehicle that
wouldn't be covered by your
warranty.
Trying
to start your Geo by
pushing or pulling it could damage
your vehicle, even if you have
a
manual transmission. And if you
have an automatic transmission, it
won't start that way.
191
ProCarManuals.com
Page 194 of 339
Problems on the Road
To Jump Start Your Geo
1. Check the other vehicle. It must have
a 12-volt battery with a negative
ground system.
If the other system isn’t a 12-volt I
system with a negative ground,
both vehicles can
be damaged.
I I
2. Get the vehicles close enough so the
jumper cables can reach, but be sure
the vehicles aren’t touching each
other.
If they are, it could cause a
ground connection you don’t want.
You wouldn’t be able
to start your
Geo, and the bad grounding could
darnage the electrical systems.
CAUTION -1
A
You could be injured if the
vehicles roll. Set the parking
brake firmly on each vehicle. Put
an automatic transmission in
P (Park) or a manual transmission
in
N (Neutral). If you have a
four-wheel-drive vehicle, be sure
the transfer case
is not in
N (Neutral).
ProCarManuals.com