1993 CHEVROLET PLYMOUTH ACCLAIM Ignition coil

[x] Cancel search: Ignition coil

Page 1071 of 2438

CHEVROLET PLYMOUTH ACCLAIM 1993  Service Manual Wiring Diagram 
Name Sheet Number 
Splice Z1-3  ............... .47, 68, 74, 77, 80, 82, 84 
Splice Z1-4  .......... .38, 47, 70, 72, 74, 77, 80, 82, 84 
Splice Z1-5  ............................. .15

Page 1285 of 2438

CHEVROLET PLYMOUTH ACCLAIM 1993  Service Manual Wiring Diagram 
Name Sheet Number 
Engine Starter Relay  .........................15 
Park/Neutral Safety Switch  .....................15 
Transmission Range Switch  .....................15 
Engine Te

Page 1286 of 2438

CHEVROLET PLYMOUTH ACCLAIM 1993  Service Manual Wiring Diagram 
Name Sheet Number 
Fuel Gauge  ............................. .107 
Fuel Pump Module  ........................ .107 
Fuel Pump Relay  .......................... .108 
Fuel Tank Gauge Le

Page 1467 of 2438

CHEVROLET PLYMOUTH ACCLAIM 1993  Service Manual WIRING DIAGRAMS AP BODY D-P
ALPHABETICAL INDEX
Wiring Diagram 
Name Sheet Number 
ABS Hydraulic Modulator Unit  .....................27 
ABS Pump Motor Relay  .........................27 
ABS System C

Page 1468 of 2438

CHEVROLET PLYMOUTH ACCLAIM 1993  Service Manual Wiring Diagram 
Name Sheet Number 
Exhaust Gas Recirculation Solenoid 2.5L  ..............13 
Exhaust Gas Recirculation Diagnostic Solenoid 3.0L.  ......20 
Fan Control System with A/C and Heater Syst

Page 1469 of 2438

CHEVROLET PLYMOUTH ACCLAIM 1993  Service Manual Wiring Diagram 
Name Sheet Number 
Horn (Lo-note)  .............................42 
Horn Relay  ...............................42 
Horn Switch  ..............................42 
Idle Air Control Motor

Page 1568 of 2438

CHEVROLET PLYMOUTH ACCLAIM 1993  Service Manual The MOPAR Silicone Rubber Adhesive Sealant 
gasket material or equivalent should be applied in a
continuous bead approximately 3mm (0.120 inch) in
diameter. All mounting holes must be circled. For
cor

Page 1673 of 2438

CHEVROLET PLYMOUTH ACCLAIM 1993  Service Manual length of the spring to be tested is 33.34mm (1-5/16 
inches). Turn table of Tool C-647 until surface is in line
with the 33.34mm (1-5/16 inch) mark on the threaded
stud and the zero mark on the front