1993 CHEVROLET CORVETTE radio controls

Downloaded from www.Manualslib.com manuals search engine Features & Controls
4
Power Door Locks
With power door locks, ,you can lock or
unlock both doors-.of your vehicle from
the driver or-passenger door lock switch.
Slide the power door
lock switch
reaward to lock the doors. Slide the
switch €ornard to unlock the doors.
Leaving Your Vehicle
If you are leaving,the vehicle, open your
door and set the lucks from inside. Then
get out and close the door.
Your vehicle has a thee detefrent
system. See- the
index uader Unzversal
Theft Deterrent.
I4
Passive KeyEess Entry System
Your Passive Keyless Entry system
operates on a radio frequency subject to
Federal Communications Commission (FCC)
Rules.
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions: (1) This
device may not cause- harmful
interfejrence,
and (2) This device must
accept any interference received,
including interference that
may cause
undesired operation. Should interference
to
this system
occur, try
this:
Check to:see if the passive feature is
enabled.
Check the distance. You may be too
far lrom your vehicle. This product
has a maximum range.
Check the location. Other vehicles or
objects-may be blocking the signal.
Check to determine if battery
replacement is. necessary.
See the
instructioas .on battery replacement
later in this section.
See your Chevrolet dealer 6r.a
qualified technician
for service.
Changes or modifications td this system
by other than an authorized service
facility could void authorization to use
this .equipment.

Downloaded from www.Manualslib.com manuals search engine Features & Controls
Ignition Switch
With the-ignition key in the ignition
switch, you can turn
the switch to five
p.ositions:
Accessory: An “on” position in which
you
can operate your .electrical power
accessories. Press in the-ignition .switch
as
you turn the top of it toward you.
Lock: The only position in which you
can remove the key. This locks your
steering wheel, ignition. and automatic
shift lever.
UE Udo:cks the steering wheel,
ignition, and automatic shift lever. Use
this pasition if your vehicle must be
pushed or towed, but never try to push-
start your vehicle-.
A warning chime will
sound if you open the driver’s door when
the ignition is
off and the key is in
the ignition.
Run: An “on” position to which the
switch returns after you start your
engine and release the switch. The
switch stays in
the Run position when
the engine is running. But -even when
the engine is-not running, you can use.
Run to operate your electrical power
accessories,
and to display some instru-
ment panel warning lights.
Start: Starts the engine, When the
engine starts, release the key. The
ignition switch will return to
Ruil fot
noma1 driving.
Note
that even if the engine is not
running, the positions
Accessory and
Run are “on” positions that allow y0.u
to operate your electrical accessories,
such
as the radio.
Key Release Button
(MANUAL TRANSMISSION)
..With a manual transmission, the
ignition key c-ot be removed from
the ignition unless the key release
button is used.
To Remove the Key:
Turn the key to the Lock position while
pressing the
key release buttoa down at
the same time. Keeping your thumb on
the button, pull the key straight out.

Downloaded from www.Manualslib.com manuals search engine Features & Controls
Charging System Light
The charging system light will come on when
you turn on the ignition, but the
engine
is not running, as a check to
show you it is working. Then it should
go out. If it stays on when the engine is
running; or comes on while you are
driving,
you may have a problem with
the electrical charging system. It could
indicate that you have. a loose or broken
drive
belt or another electrical problem.
Have it checked right away. Driving
while thisJight
is. on could drain your
battery.
If you must drive a short distance with
the lght un, be certain to turn of€ aU.
your accessories, such as the radio and
air conditioner.
Low Oil Light
This light will come on for a few
seconds wheri
you start your vehicle
and
will stay on if your oil is '/z to 1%
quarts low (with the vehicle nearly
level).
See the Index under Engine UiE.
For the LT5 Engine Only: If this light
comes on, and you need to verify the oil
level, let
your vehicle sit for approximately
two hours
with the engine off before
checlung the
oil, See the Index under
Checking Engine Oil Level for the
proper procedure.
You should check your oil level
regulariy.
This light is an added
reminder.
Malfuncfion Indicator Lamp
(Senrice hghe Soon Light)
A computer monitors operation of your
fuel, ignition and emission control
systems. This light should
come on
when the ignition is on, but the engine
is not running,
as a check to show you it
is working. If
it does not come on at all,
have it fixed right away. If it stays on, or
it comes on while you
are driving, the
computer is indicating th,at you have a
problem.
You should take your vehicle
in for service soon.

Downloaded from www.Manualslib.com manuals search engine h
P
To Reset Your System:
1. Turn your ignition.lrey to Off or
Lock.
2. Pull the Courtesy Lights Fuse and
Radio Fuse .out of the- main fuse
panel for
one minute.
3. Put-the fuses back in and start your
vehicle. Your system shuuld be
working.
If you still have a problem,
see your deder,
.For
fuse location, see the Index under
Fuses E. CircuitBreakers and Fuse
.Panel.
Directional Controls
When the €allowing buttons are pressed,
an indicator light.
will glow above .the
button and the fan speed will go to
AUTO 3f unless you select a dBerent
speed. When the system is'changed
€rum
OFF tu any mode, the inside
temperature setting is displayed for
several seconds before the .outside
temperature is again displayed.
& (Maximum A/C): Use for
maximum cooling
or quick cool-down
on very hot days..
This setting will not
operate when outside temperatures are
below
40°F (5°C) I
-2 (Bi-Level): This setting lets air
inte the vehicle only through the
.heater and air conditioner outlets and
brings.the temperature
to the range
you choose. It controls the fan blower
speed by using t-he input signals.
Bi-Level al.so
defogs the side windows,
You can. override the,fan blower speed
by using
the V and A buttons.
a(Vent): In this setting, the
compressor
will not. mn. The-system
will adju-st
to the temperature you
choose, but it cannot cool the vehicle
to a temperature colder than the
outside air temperature, This setting

Downloaded from www.Manualslib.com manuals search engine Comfort Controls & Audio Systems
The following .pages describe the audio
systems available for your Corvette, and
how to get the best performance from
them.. Please read about ,the system in
your vehicle.
'I I46
CAUTION I
A
Hearing damage from loud
noise is almost undetectable
until it is too late. Your hearing can
adapt to. higher volumes of sound.
Sound that s-eems normal.can-be
loud and
harmful to your hearing.
Take precautions by adjusting the
volume control
on your radio to-a.
safe sound
level before yaur hearing
adapts to it.
To help avoid hearing loss OK
damage:
1. Adjust the volume control to the
lowest setting.
2. Increase volume slowly until you
hear comfortably and clearly.

Downloaded from www.Manualslib.com manuals search engine Comfort Controls & Audio Systems
Accessory Wiring Plug (CONTJ
This Wiring Plug has Three Separate
Wires:
The orange wire connects to the
battery.
The pink wire connects to the ignition
(power
is only available in the Run
position).
ground.
The black wire connects to the
When.using $he.accessory wiring
Don't splice wires -directly into
the
accessory plug wire. If done
incmrectly, splicing might cause
damage.to pur electrical system.
The maximum bad dany ' , .
electric,al,equipment..shauld.not
exceed I15 amps, . .
.Be sure to turn off any electricai
equipment when-not-in
use..
Leaving electrical equipment on
€or extended periods ..can drain
your battery.
electrical equipment
you're using
requires frequent connecting and disconnecting. This may
cause
excessive wear on the accessory
plug
and damage your eiectricai
system.
.plug:
Do not use this plug if the
Y3074
ietting the Clock
ietting the cloclc is easy.
, With the radio on or off and the
ignition on, press
SET. The SET
indicator light will glow for five
seconds.
!. You must begin to set the clock to
the correct hour and minute during
those five seconds. Set the clock
by
pressing the TUNE button. TUNE 7
will set the hour. TUNE A sets the
minute.

Downloaded from www.Manualslib.com manuals search engine P
E""
F
IMjFM Stereo wjth Cassette
'layer
qOL/PROG/RCL Turns the unit on
md off when the ignition is on.
Idjusts volume up or down.
BAIJFADE: Turn the inside control
mob to adjust the sound from the left
:o the right speakers.
rum the control ring to adjust the
bund
from the front to the rear
;peakem.
Radio Controls:
The digital display indicates infomation
on time or radio stationfrequency, the
AM or FM radio band, whether the
station is
in stereo, and other radio
functions.
AMEM: Press this button to select
either the
AM or FM radio band. The
band
you select will be displayed on
the digital screen. The frequency of the
station
will be displayed, and if the
station is in stereo, the
ST indicator
will also be displayed.
RCL (Recall): Press to change
between the clock or the radio station
frequency displayed on the digital
screen.
AUTO: Press this button, then press
TUNE to tune to the next station on
the AM or FM band.
An indicator light above
a preset station
button
will glow when the seek mode
stops at that station.

Downloaded from www.Manualslib.com manuals search engine Comfort Controls & Audio Systems
AMlFM Stereo with Cassette
PIayer (cum)
TUNE. Press this control to tune in.
stations higher or lower on the AM.or
FM radio band. For rapid tuning, press
and hold one side of.TUNE., then:press
the other side. The display will revert
to time if the tuning activity has
ceased for approximately five sec0nd.s.
BASWXREB (Treble): The inside
knob adjusts the bass level up or
down. The autside ring;adjQsts the
treble level up or down.
To Preset Radio Stations:
The six numbered- pushbuttons can be.
used to preset up to twelve-radio
stations (six AM -and six FM stati.ons).
1. Tune in the desired station.
2, Press SET. The SET indicator light
will glow.
3. While the SET indicator. light- glows,
press one. of the six pushbuttons.
Whenever
you press this button again,
the preset station will be tuned in.
4. Repeat steps 1-3 -for each of six AM
and six FM stations,
To Play a Cassette Tape:
This audio system has automatic.
on Dolby B NR@- to reduce background
noise. on Dolby encoded tapes. Dolby"
Noise Re:du.ction is manufactured under
license from Dolby Laboratories
Licensing Corporation.
Dolby@ and the
00 symbol are trademarks of Dolby
Laboratories Licensing Corporation.
Turn the VOL 1Znd.b.ts turn the radio
on. Then push a Cassetteinto the
cassette entry door (the tape side goes
in :first). Do not use tapes-that are
loQger- than 45 minutes on each,:side.
The
display will indicate CA IN when a
cassette tape is in tkplayer.