1993 CHEVROLET ASTRO PASSENGER audio

Downloaded from www.Manualslib.com manuals search engine How to Operate Your ETW AM-FM Stereo Audio
Cassette System
K4310
This part tells you how your ETR@ AM-FM stereo audio cassette sound
system works:
The Upper Knob
The upper knob does these four things:
It controls the volume.
It lets you know what station you're listening to. (When the \
radio is on,
It tells you the time. (When the ignition is off, push the knob to display
push the knob
to display the station.)
the time.)
It allows you to hear the other side of the tape. (Press knob while
The control behind the upper knob moves the sound between your\
left and right speakers. cassette
is playing.)
The Lower Knob
Turn the lower knob to choose radio stations. Push it to get AM or FM.
The
control behind the lower knob moves the sound between your fro\
nt and rear
speakers.
3-1 5

Downloaded from www.Manualslib.com manuals search engine Comfort Contmls & Audio Systems
Tone Levers
These two levers control the tone of your radio.
BASS-Slide this lever up
to hear more bass.
TREBLE-Slide this lever up
to hear more treble.
Adjust these levers
to give a pleasing sound. If a station is weak and noisy,
move TREBLE down
to reduce the noise.
P WR (Power)
The PWR button turns your system on and off.
DNR@ Button
This is the Dynamic Noise Reduction button. It helps remove background hiss
noise from the radio or tape player. You may want
to leave it pushed in all
the time.
DNR@ is a registered trademark of National Semiconductor Corporation.
Pushbuttons
The four pushbuttons let you return to favorite stations.
You can set the pushbuttons for up to eight favorite stations
(4 AM and
4 FM). Just:
1. Tune in the station.
2. Push SET. (SET will be displayed.)
3. Within 5 seconds, push one of the four pushbuttons. Whenever you push
that button, the preset station
will return.
Repeat these steps for each pushbutton.
You can preset
3 more stations on each band by pushing a pair of buttons
next
to each other at the same time. Just:
1. Tune in the station.
2. Push SET. (SET will be displayed.)
3. Within 5 seconds, push two buttons next to each other at the same
time. Whenever you push that pair of buttons, the preset stati\
on will return.
Repeat these steps for each pair of buttons.
Scan Button
When you push this, the radio will go to the next station and stay there a
few seconds. Then
it will go to the next station and pause, and keep doing
that. Press SCAN again
to stop scanning.
3-1 6

Downloaded from www.Manualslib.com manuals search engine Comfort Controls & Audio Sysfems
How to Operate Your ETF AM-FM Stereo Audio
Cassette System with Equalizer
K4372
This part tells you how your ETR@ AM-FM stereo audio cassette system with
equalizer works.
The Upper Knob
The upper knob does these four things:
It controls the volume.
It lets you know what station you’re listening to. (When the \
radio is on,
It tells you the time. (When the ignition is off, push the knob to display
It allows you to hear the other side of the tape. (Press knob while
The control behind the upper knob moves the sound between your left and
right speakers.
The Lower Knob
Turn the lower knob to choose radio stations. Push it to get AM or FM. An
indicator light appears when you tune to an
FM stereo station. The control
behind the lower knob moves the sound between your front and \
rear
speakers. push the knob to display the station.)
the time.)
cassette is playing.)
3-1 8

Downloaded from www.Manualslib.com manuals search engine Tone Levers (Equalizer)
The 5 levers near the upper knob control the tone of your radio.
Use the levers to set the bass, midrange, and treble until you get th\
e sound
you prefer. The
60 and 250 levers adjust the bass; 1K is midrange; and 3.5K
and 10K adjust the treble.
PWR (Power)
The PWR button turns your system on and off.
Loud Button
Press this for more bass sound; press again to remove it.
AM-ST Button
Push this button if you want AM stereo. (“STEREO’ will be displayed when
you are receiving an
AM stereo station.)
Cr02 Button
The Cr02 button lets you set the system for the type of cassette being used.
If you are using chrome or metal tapes, push the Cr02 button in. If you are
using standard iron tapes, make sure the button is out.
DN@
Your audio system has automatic Dynamic Noise Reduction. It helps remove
background hiss noise from the radio or tape player.
DNR@ is a registered trademark of the National Semiconductor Corporation.
Pushbuitons
The four pushbuttons let you return to favorite stations.
You can set the pushbuttons for up to eight favorite stations
(4 AM and
4 FM). Just:
1. Tune in the station.
2. Push SET. (SET will be displayed.)
3. Within 5 seconds, push one of the four pushbuttons. Whenever you push
that button, the preset station
will return.
Repeat these steps for each pushbutton.
3-1 9

Downloaded from www.Manualslib.com manuals search engine Comfort Controls & Audio Systems
You can preset 3 more stations on each band by pushing a pair of buttons
next to each other at the same time. Just:
1. Tune in the station.
2. Push SET. (SET will be displayed.)
3. Within 5 seconds, push two buttons next to each other at the same
time. Whenever you push that pair
of buttons, the preset station will
return.
Repeat these steps
for each pair of buttons.
Scan Button
When you push this, the radio will go to the next station an\
d stay there a
few seconds. Then it will go to the next station and pause, and keep doing
that. Press
SCAN again to stop scanning.
Seek Button
This chooses stations also, but it doesn’t keep moving as SCAN does. When
you push
SEEK, the radio goes to the next station
Clock
To set the clock, just:
1. Push SET. (SET will be displayed.)
2. Within 5 seconds, push and hold SCAN until 1 :t-
ahd stays there.
le correct hour appears.
3. Press and hold SEEK until the correct minute appears.
To display the clock with the ignition
off, push the upper knob. The time will
be displayed for a few seconds.
3-20

Downloaded from www.Manualslib.com manuals search engine Comforf Controls & Audio Systems
Care of Your Cassette Tape Player
A tape player that is not cleaned regularly can cause reduced so\
und quality,
ruined cassettes, or a damaged mechanism. Cassette tapes should \
be stored
in their cases away from contaminants, direct sunlight, and extreme\
heat.
If
they aren’t, they may not operate properly or cause failure of the tape player.
Your tape player should be cleaned regularly each month
or after 15 hours of
use. If you notice a reduction in sound quality, try a known good cassette to
see if the tape or the player is at fault. If this other cassette has no
improvement in sound quality, clean the tape player.
Clean your tape player with a wiping-action, non abrasive clean\
ing cassette,
and follow the directions provided with it.
Cassettes are subject to wear and the sound quality may degrad\
e over time.
Always make sure that the cassette tape is in good condition before you
have your tape player serviced.
I
K1313
3-22

Downloaded from www.Manualslib.com manuals search engine How to Operate Your ETP AM-FM Stereo Audio
Compact
Disc (CD) System
1
This part tells you how your ETR@ AM-FM stereo system works:
P WR (Power)
The PWR button switches the radio on and off when the ignition is on.
Upper Knob
The upper knob does these two things:
It controls the volume. Volume will increase when the VOL knob is
turned clockwise and decrease when turned counterclockwise. Volum\
e will be displayed briefly unless the LeftlRight speaker control, Rear/Front
speaker control,
BASS or TREB are adjusted.
It controls the mute feature. By pressing the MUTE knob, all sound from
the radio or
CD player stops. By pressing the knob again, or by turning
the VOL knob clockwise, sound will begin again.
LeWRight Speaker Control
The control behind the upper knob allows you to balance the sound between
the right and left speakers. Balance will be displayed briefly \
when using this control.
Lower Knob
The lower knob does these two things:
clockwise or counterclockwise.
It enables you to tune in different radio stations by turning the\
knob
3-23

Downloaded from www.Manualslib.com manuals search engine Comfort Contmls & Audio Systems
REV
Press and hold the REV button to quickly return to a favorite passage. The
counter reading will be displayed when using this control.
FWD
Press and hold the FWD button to advance quickly within a track. Release it
to resume playing. Watch the display to stop at a specific pa\
ssage.
SCAN
Press SCAN to sample each track for approximately 10 seconds. Scanning
will continue until the
RDM, SCAN or any other motion button is pressed
again.
PREV
If you hold the PREV (4 SEEK) button, or press it more than once, the disc
will return to previous tracks.
NEXT
Press NEXT (SEEK b) to hear the next track now instead of waiting until the
present track is finished.
If you hold this button or press it more than once,
the disc
will advance further.
ST-Pf
Press ST-PL (Stop-Play) to make the disc stop and the radio play. Press
ST-PL again to restart the disc at the point where it stopped.
Press
PWR or turn the ignition key off to stop the disc player. The disc stays
in the player and will resume playing at the point where it \
stopped.
Press
EJECT to eject the disc and make the radio play. The disc will sta\
rt at
tract
1 when you reinsert it.
Anti-Theft Feature
Delco LOC Il@ is an Anti-Theft feature for the compact disc player. It can be
used or ignored. If ignored, the system plays normally.
If it is used, your
player won’t be usable if it is ever stolen, because it wo\
n’t turn
on.
The instructions below tell you how to enter a secret code in\
to the system. If
your car loses battery power for any reason, you must unlock \
the system with
the secret code before the radio will turn on.
To Lock The System:
1. Write down any 6 digit number and keep it in a safe place.
2. Turn the ignition to the “Accessory” or “Run” position.
3. Press the PWR button to turn the radio off.
3-26