1993 BUICK CENTURY boot

ITEM
NO. SERVICE
9 Spark Plug Wire Inspection**-Inspect for
bums, cracks or other damage. Check the boot
fit at the distributor and at the spark plugs.
Replace wires as needed.
10 Exhaust Gas Recirculation (EGR) System
Inspection (2.2L Code 4 engine only)**-
Conduct the EGR system service as described in
the service manual.
To purchase a service
manual, see “Service Publications” in the Index.
ITEM
NO. SERVICE
12
Air Cleaner Filter Replacement*-Replace
every
30,000 miles (50 OOO km) or more often
under dusty conditions. Ask your dealer for the
proper replacement intervals for your driving conditions.
Fuel %nk, Cap
and Lines Inspection* A-
Inspect fuel tank, cap and lines (including fuel
rails and injection assembly, if equipped) for
damage or leaks. Inspect fuel cap gasket for an
even filler neck imprint or any damage. Replace
parts as needed. Periodic replacement of the fuel
filter is not required.
*An Emission Control Service.
*The
U.S. Environmental Protection Agency has determined that the failure to perform this maintenance item will not nullify the emission warranty
or limit
recall liability prior to the completion of vehicle useful life. General Motors, however, urges that all recommended maintenance services be
performed at the indicated intervals and the maintenance be recorded in “Section E: Maintenance Record.”
286
ProCarManuals.com

Section C: Periodic Maintenance Inspections
Listed below are inspections and services which should be performed at least\
twice a year (for instance, each spring
and M1). You should let your
GM dealer’s service department or other qualified service center do these jobs. Make
sure any necessary repairs are completed at once.
INSPECTION
OR SERVICE
Steering, Suspension
and Front-Wheel- Drive Axle Boot and
Seal Inspection
Exhaust System
Inspection
~~~~ ~~
Throttle Linkage
Inspection
WHAT SHOULD BE DONE
Inspect the front and rear suspension and steering system for \
damaged, loose or missing
parts, signs of wear, or lack
of lubrication. Inspect the power steering lines and hoses for
proper hookup, binding, leaks, cracks, chafing, etc. Clean and \
then inspect the drive axle
boot
seals for damage, tears or leakage. Replace seals if necessary.
Inspect the complete exhaust system. Inspect the body near the \
exhaust system. Look for
broken, damaged, missing or out-of-position parts as well as op\
en seams, holes, loose
connections, or other conditions which could cause a heat build\
-up in the
floor pan or could
let exhaust fumes into the vehicle. See “Engine Exhaust”
in the Index.
Inspect the throttle linkage for interference or binding, and f\
or damaged or missing parts.
Replace parts as needed.
290
ProCarManuals.com