REAR WIPER AND WASHER S
Wiper
Washer
1. Rear hatch lower trim
7. Trunk end trim
Removal / Installation . . . . . . . . . . . . . . . . page S-
98 Removal / Installation . . . . . . . . . . . . . . . . page
S- 98
2. Wiper arm cover 8. Trunk side cover
3. Rear wiper arm and blade Removal / Installation . . . . . . . . . . . . . . . . page S-
98
Adjustment
Note . . . . . . . . . . . . . . . . . . . . . . . page S- 79 9. Trunk side trim
4. Seal cap Removal / Installation . . . . . . . . . . . . . . . . page S-
98
5. Outer bushing 10. Rear header trim
6. Rear wiper motor Removal / Installation . . . . . . . . . . . . . . . . page S- 98
Inspection .,, ., . . . . . . . . . . . . . . . . . . . . . . . . . . . .
page S- 77 11. Rear seat belt upper anchor
Removal / Installation . . . . . . . . . . . . . . . . page S-l 01
12. C-pillar trim
Removal / Installation . . . . . . . . . . . . . . . . page S-
98
13. Washer tank assembly
a. Washer tank
b. Washer motor
Inspection . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
page S- 77
14. Washer nozzle
Adjustment Note . . . . . . . . . . . . . . . . . . . . . . . page S-
79
15. Washer pipe
23UOSX-032
REAR WINDOW MOLDING
mm (in)
03uosx-14
REAR WINDQW MOLDING I
mm (in
03uosx-14
Adjustment Note
Arm height
1. Set the motor shaft to the park position by turning the rear
wiper switch from ON to OFF.
2. Set the arm height as shown in the figure.
Tightening torque:
5.9-9.8 N*m (80-100 cm-kg, 52-87 in-lb)
Washer nozzle
Inset-t a needle or similar object into the nozzle hole and move
the nozzle to adjust the spray direction.
s-79
SLIDING SUNROOF S
03UOSX-16d
(SUNROOF) (MOONROOF)
03UOSX-16!
ADJUSTING SCREW
SECA-A
D
__--__..-- ---__.-__
031JOSX 16
__-__
-~-
03UOSX-16
2. Install the guide rail cover and set plate.
3. Turn the motor using the emergency handle, and visually
check the sliding, tilt-down and tilt-up operations.
Adjustment Note
Sliding panel assembly
Height
Adjust so that the height difference between the sliding panel
and the roof panel is
1.5mm (0.06 in) max, referring to below.
(Front portion)
1. Loosen installation screws (1) and (2).
If the adjustment is only about
2mm (0.08 in) don’t loosen
screw (1).
2. Turn the screws to adjust.
Turning to the right raises; to the left lowers.
3. Tighten installation screws (1) and (2).
(Rear portion)
1. Loosen the adjusting screw.
2. Adjust by moving the sliding panel.
3. Tighten the adjusting screw.
S-987
