MAINTENANCE
149
Explanation of scheduled maintenance items
ENGINE COMPONENTS AND EMISSION CONTROL
SYSTEMS
Timing belt
(Applicable to Schedule A only.) When scheduled, replace the
belt and inspect the ignition timing. A qualified technician must
perform these operations.
Valve clearances
Adjust the valve clearances to factory specifications. A
qualified technician should perform this operation.
Drive belt
Inspect the drive belts for cracks, excessive wear or oiliness.
Replace belt it damaged. Check the auto tensioner operation.
Engine oil and oil filter
Change the engine oil and oil filter when scheduled. Use API
grade SG, Energy-Conserving II multigrade engine oil. A
qualified technician should perform this operation.Engine coolant
Drain and flush the cooling system when scheduled, Refill only
with an ethylene-glycol type coolant. A qualified technician
should perform this operation.
Exhaust pipes and mountings
Visually inspect the exhaust pipes, muffler and hangers for
cracks, deterioration, or damage. Start the engine and listen
carefully for any exhaust gas leakage. Tighten connections or
replace parts as necessary.
Air filter
Replace the air filter when scheduled. Do-it-yourself
instructions are given on page 170. If you mainly operate your
vehicle on dusty roads, additionally inspect and clean the air
filter when scheduled. Visually check for dirt or damage. It may
be cleaned with compressed air.
Fuel lines and connections
Visually inspect the lines, connections and tank band for
corrosion, damage, cracks, and loose or leaking connections.
Tighten connections or replace parts as necessary.
Fuel tank cap gasket
Make sure the new gasket is correctly installed.
