H CLUTCH MASTER CYLINDER (BP DOHC TURBO OR WITH ABS)
Disassembty Note
Snap ring
Caution
l Do not damage the push rod contact surface of the
piston.
1. Press the piston down and remove the snap ring with snap-
ring pliers.
Piston and secondary cup assembly
Caution
l Hold a rag over the master cylinder to prevent the
piston and secondary cup assembly from jumping
out.
1. Remove the piston and secondary cup assembly, spacer,
and primary cup by applying compressed air through the
clutch pipe installation hole.
One-way vaive piston and return spring
Caution
l Hold a rag over the master cylinder to prevent the
piston and spring from jumping out.
1. Remove the piston by applying compressed air through the
cylinder bore.
Assembly Note
Caution
l Before assembly, make sure all parts are completety
clean.
l Do not mix different brands of clutch ftuid.
l Do not reuse the clutch fluid that was drained.
l Apply the specified clutch fluid to the piston and
secondary cup assembty, spacer, primary cup, and
cylinder bore before assembly.
l Replace parts with new ones whenever specified to
do so.
03uot-!x-019
Piston and secondary cup assembty
1. InstaD the spring, primary cup, spacer, and piston and
secondary cup assembly, noting the proper direction of the
parts.
CLUTCH MASTER CYLlNDER (BP DOHC TURBO OR WITH A8S), CLUTCH RELEASE CYLINDER (WITH AN) H
Snap ring
Caution
l Do not damage the push rod contact surface of the
piston.
t . While pressing the piston, install the snap ring.
CLUTCH RELEASE CYLINDER (WITH ABS)
PREPARATION
SST
49 0259 770B
Wrench, flare nut For disconnecting
and connecting
clutch pipe
93GOHX-724
AIR BLEEDING (WITH ABS)
I_ After installation, bleed the clutch system.
(Refer to page H-16.)
93GOHX-725
H-17
