1989 MITSUBISHI MONTERO wheel

INTRODUCTION MASTER TROUBLESHOOTING - Master Troubleshootha
POOR RETURN OF STEERING WHEEL TO CENTER
Symptom Probable cause Reference
page or remedy
Poor return of steering
wheel to center improper front wheel alignment 2-13
Improper tire pressure 22-2
Damaged front wheel bearing 2-21
POOR RIDING
Probable cause Reference
page or remedy
Poor riding Impropertire pressure
lmbalanced wheels 22-2
22-4
1 Improper front or rear wheel alignment 1 2-13.17-3.6
1 Malfunctioning shock absorber 1 2-27,174.a
1 Broken or worn stabilizer
1 Broken or worn torsion bar spring j 2-36
I
Loose suspension securing bolt(s) Retighten
I
1 Worn lower arm bushing / 231
I
ABNORMAL TIRE WEAR
Symptom Probable cause Reference
page or remedy
Abnormal tire wear Improper front or rear wheel alignment 2-l 3,17-3.6
Improper tire pressure 22-2
lmbalanced wheels 22-4
Loose wheel bearings 2-19
Malfunctioning shock absorber 2-27. 174.8
ROAD WANDER
Symptom Probable cause Reference
page or remedy
Road wander z Improper front or rear wheel alignment 2-13. 17-3,6
Excessive play of steering wheel 19-6
Poor turning resistance of upper ball joint ~ 2-27
Improper tire pressure 22-2
/ Loose or worn lower arm or upper arm bushing 2-28.31
Loose or worn wheel bearinas
I
[ TSB Revision
I 2-19
1 ~- __
- rr.

INTRODUCTION AND MASTER TROUBLESHOOTING - Master Troubleshootina 29
VEHICLE PULLS TO ONE SIDE
Symptom
Vehicle pulls to one side Probable cause
Improper front or rear wheel alignment
lmbalanced or worn tires
Uneven tire pressure
Excessive turning resistance of upper ball joint
Wheel bearing seizure
Broken or worn torsion bar spring
Bend front axle drive shaft
Deformed lowerarm Reference
page or remedy
2-l 3.17-3.6
/ 224
22-2
2-27
2-21
2-36
2-40
230
STEERING WHEEL SHIMMY
Symptom Probable cause Reference
page or remedy
Steering wheel shimmy Improper front or rear wheel alignment 1 2-13,17-3,6 1
Improper tire pressure 1 22-2
I
Imbalanced wheels Repair
I
1 Poorturning resistance of upper ball joint
Excessive play of steering wheel 1 2-27
I
19%
I
Broken or weak stabilizer 1 2-39
I
Worn lower arm or upper arm bushing I 2-28.31 1
Malfunctioning shock absorber I 2-27
I
/ Broken or weak torsion bar spring or, leaf spring or coil spring / 2-36,17-4,9
Wear, play, or seizure of wheel bearing 2-19
BOTTOMING
Symptom Probable cause Reference
page or remedy
Bottoming Overloaded vehicle Correct
Broken or weak torsion bar spring, leaf spring or coil spring 236.1749
1 Malfunctionina shock absorber 1 2-27,174 8 1
( TSB Revision

I”! 1: 1’ --- -~~
30 INTRODUCTION AND MASTER TROUBLESHOOTING
- Master Troubleshooting
WHEEL BEARING TROUBLESHOOTING
Trouble Symptom
Probable cause
Pitting
Flaking
Cracking Chipping or cracking of cage or roller edges
Flat spotting When large load is applied, race and roller contact
surfaces compress, forming indentations
Nicks
?ust, corrosion
Near
Xscoioration Pitting occurs because of uneven rotation of race
and bearing surfaces
The surface peels because of uneven rotation of
the race and bearing surfaces
Instead of rolling along race surface,
rollers slide, thus damaging surface
Damage or wear caused by minute particles
adhering to surfaces results in rough movement
and such high temperatures that parts of surface
melt
Appears on various areas of the bearing
Wear of surface areas caused by friction
Grease discoloration results from grease
deterioration which causes particles of pigment
contained in grease to adhere to surfaces
Heat discoloration will appear as a deep brown or
purple Excessive bearing preload
Excessive load
End of bearing life
Improper bearing assembly
Impact when bearing was
installed (such as being hit
with a hammer)
Excessive bearing preload
Excessive load
Vibration when bearings are
not used, such as during
shipment on freight cars,
transport trucks, etc.
Improper grease
Excessive bearing preload
Excessive load
Faulty oil seal
Excessive variation of loads on
bearings
Use of grease other than that
specified
Improper grease
Use of grease otherthan
that specified
Faulty oil seal
Presence of water or moisture
Improper grease
Foreign matter
Rust or corrosion due to
moisture
Use of grease otherthan that
specified
Faulty oil eal
Use of grease other than
that specified
Faulty oil seal
Excessive bearing preload
Excessive load