EFI SYSTEM - Troubleshooting with Volt/Ohmmeter (MA)
FI-35
. .
EFI SYSTEM CHECK PROCEDURE
NOTE:
l Perform all voltage measurements with the connectors
connected.
0 Verify that the battery voltage is 11V or above when
the ignition switch is at “ON”.
Using a voltmeter with high-impedance (IO kQ/V
minimum), measure the voltage at each terminal of the
wiring connectors.
I ) ECU +B
Terminals of ECU (7M-GE)
Symbol ) Terminal Name
E01 POWER GROUND
E02 POWER GROUND
No. 10 INJECTOR (No. 1 and 4)
No. 20 INJECTOR (No. 2 and 6)
STA STARTER SWITCH
No. 30 INJECTOR (No. 3 and 5)
STJ COLD START INJECTOR
El COMPUTER GROUND
NSW NEUTRAL START SWITCH (A/T)
N/C *CLUTCH SWITCH (M/T) 1 Symbol) Terminal Name
T CHECK CONNECTOR
G2 DISTRIBUTOR
VTA THROTTLE POSITION SENSOR
NE DISTRIBUTOR
IDL THROTTLE POSITION SENSOR
IGT IGNITER
IGF IGNITER
THW WATER TEMP. SENSOR Symbol
Terminal Name
L3 ECT COMPUTER
EGR
vsv (EGR)
A/C A/C MAGNET SWITCH
SPD SPEEDOMETER
W WARNING LIGHT
FPR FUEL PUMP RELAY
DFG
DEFOGGER RELAY
THA
AIR TEMP. SENSOR
ECT
ECT COMPUTER
vs AIR FLOW METER
KNK KNOCK SENSOR LP HEADLIGHT RELAY
ISC 1 ISC MOTOR NO. 1 COIL ox OXYGEN SENSOR vc THROTTLE POSITION SENSOR
AIR FLOW METER
ISC 3 ISC MOTOR NO. 3 COIL E2 SENSOR GROUND
ISC 2 ISC MOTOR NO. 2 COIL VSV 1 VSV (AIR CONTROL)
BATT BATTERY
ISC 4 ISC MOTOR NO. 4 COIL Ll ECT COMPUTER +B EFI MAIN RELAY
GQ DISTRIBUTOR VSVP VSV (FPU) IG S/W IGNITION SWITCH
VF CHECK CONNECTOR
Gl DISTRIBUTOR
ECU Terminals 1 L2 ECT COMPUTER
+Bl EFI MAIN RELAY
1 M-REL EFI MAIN RELAY (COIL)
*For cruise control
F10574
FI-36 EFI SYSTEM - Troubleshooting with VoltjOhmmeter (MA)
Terminals of ECU. (7M;GTE)
Symbol Terminal Name Symbol Terminal Name Symbol Terminal Name
EOI POWER GROUND G2 CAM POSITION SENSOR A/C A/C MAGNETIC SWITCH
E02 POWER GROUND VTA
THROTTLE POSITION SENSOR SPD SPEEDOMETER
No, 10 INJECTOR (No. 1 and 4)
NE CAM POSITION SENSOR W
WARNING LIGHT
No. 20 INJECTOR (No. 2 and 6) IDL
THROTTLE POSITION SENSOR FPR FUEL PUMP RELAY
STA STARTER SWITCH IGT IGNITER OIL OIL PRESSURE SWITCH
No. 30 INJECTOR (No. 3 and 5) IGdA IGNITER THA AIR TEMP. SENSOR
STJ COLD START INJECTOR
IGF IGNITER ECT ECT COMPUTER
rEl COMPUTER GROUND KNKl KNOCK SENSOR
t HAC 1 tl
NSW
NEUTRAL START SWITCH (A/T) THW WATER TEMP. S
N/C ‘CLUTCH SWITCH (M/T) KNK2 KNOCK SENSOR 1 vc ) THROTTLE
AIR
FLOW I
LTITUDE COMPENSATION
, .xNSOR
ENSOR 1 FC 1 CIRCUITOPENING RELAY I
IGdB IGNITER ox OXYGEN SENSOR KS AIR FLOW METER
ISC 1 ISC MOTOR NO. 1 COIL E2 SENSOR GROUND BATT BATTERY
r
ISC 3 ISC MOTOR NO. 3 COIL
vsv VSV (FPU) +B EFI MAIN RELAY
ISC 2 ISC MOTOR NO. 2 COIL Ll ECT COMPUTER IG S/W IGNITION SWITCH
ISC 4 ISC MOTOR NO. 4 COIL HT OXYGEN SENSOR +Bl EFI MAIN RELAY
GO CAM POSITION SENSOR L2 ECT COMPUTER TIL
TURBO INDICATOR
VF CHECK CONNECTOR M-REL
EFI MAIN RELAY (COIL) DFG DEFOGGER RELAY
Gl CAM POSITION SENSOR L3 ECT COMPUTER LP HEADLIGHT RELAY
T CHECK CONNECTOR
EGR VSV (EGR)
ECU Terminals
E2 Ll L2 L3 A/C W OIL ECT FC KS +B +Bl
+
F10574 Fll 99:
*For cruise control
