AUDIO SYSTEM - Radio and Tape Player e-197
RADIO AND TAPE PLAYER
REMOVAL AND INSTALLATION NOINJAF
16W1519
Post-installation Operation l Adjustment of Antenna Trimmer
(Refer to P.8-196.) Removal steps
1. Knob
2. Plug
3. Center console
4. Connection of center panel wiring har-
ness to front wiring harness connector 7. Radio
8. Tape player
9. Box (Vehicles without tape player)
5. Radio panel
6. Radio bracket NOTE
Reverse the removal procedures to reinstall. 1 STB Revision
HEATERS - Ventilators 24-17
2OW75l
2OW759
2. REMOVAL OF LAP HEATER GARNISH
While using a screwdriver to pry the lock of the lap heater
garnish, use another screwdriver to pry the end of the lap
heater garnish to remove it.
6. REMOVAL OF LAP HEATER DUCT (A)
Remove the screw at the side of the instrument panel, and
then remove the lap heater duct (A).
7. REMOVAL OF DEFROSTER DUCT (R.H.)/8. AIR DUCT
(R.H.)
(1) Open the glove box lid.
(2) Remove the glove box stopper.
(3) Pull the glove box outward.
(4) Remove the defroster duct (R.H’.)
(5) Remove the air duct (R.H.)
9. REMOVAL OF LAP HEATER DUCT (A)
(1) Remove the center panel. (Refer to GROUP 23 BODY -
Floor console)
(2) Remove the heater control assembly. (Refer to P.24-9)
(3) Insert a hand through the heater control assembly
installation hole in the instrument panel, and remove
the installation screw of the lap heater duct (A).
1 STB Revision 10. REMOVAL OF AIR DUCT (L.H.)
(1) Remove the combination meter. (Refer to GROUP 8 HI
ELECTRICAL-Meters and Gauges)
(2) Remove the air duct (L.H.).
11. REMOVAL OF INSTRUMENT PANEL
Refer to GROUP 23 BODY-Instrument Panel.
