1986 TOYOTA LAND CRUISER garage door opener

I25809
BE2F0-01
I25810
I25811
BE-190
- BODY ELECTRICALGARAGE DOOR OPENER SYSTEM
2563 Author
: Date
:
2004 LAND CRUISER (RM1071U)
INSPECTION
1. INSPECT GARAGE DOOR OPENER SWITCH
Press the switch and check that each LED (red) lights up.
Even if only one switch is found not to light up, replace it.
2. INSPECT GARAGE DOOR OPENER REGISTRATION
AND TRANSMITTING
HINT:
Use the home link tester made by KENT MORE for this test.
As it is necessary to record the code of the hand held transmit-
ter, customer's code will be erased. When the inspection com-
pletes, please register the customer's again.
(a) Check that the code of hand held transmitter for inspec-
tion can be recorded (See page BE-186).
If the code can not be registered, replace garage door opener.
(b) Press the switch which an inspection code has been reg-
istered for and check that LED (green) of the home link
tester lights up.
If the LED (green) does not light up, replace the garage door
opener.

BE0TZ-06
I25525
Grage Door Opener Switch
Cowl Side J/B RH

DOME Fuse
- BODY ELECTRICALGARAGE DOOR OPENER SYSTEM
BE-189
2562 Author
: Date
:
2004 LAND CRUISER (RM1071U)
LOCATION

BE0TY-04
I25812
BE-186
- BODY ELECTRICALGARAGE DOOR OPENER SYSTEM
2559 Author
: Date
:
2004 LAND CRUISER (RM1071U)
GARAGE DOOR OPENER SYSTEM
REGISTRATION PROCEDURE
1. NEW CODE REGISTRATION
NOTICE:

If pressing the switch of the original transmitter to
register the code, the system might operate.

When registering the transmitter codes such as for
garage or gate, check that there is nobody around
those places then register.
(a) Press the switch for the item to be registered for 20 se-
conds
HINT:
When transferring to registration mode, LED (red) blinks in 1 Hz
cycle.
(b) In the condition of (a), bring the original transmitter to with-
in 1-inch area around the garage door opener and press
the switch. (code transmitting).
HINT:
When code registration completes correctly, LED (red) blinks in
5.6 Hz cycle.

I03487
GARAGE DOOR
OPENER SWITCH
LEARN MODE
LED
OPERATION
ORIGINAL
TRANSMITTERPRESSED
ENTER
EXIT
ON
OFF20 sec
LED flashes
at a rate of 1 Hz
LED flashes at a
rate of 5.6 Hz PRESSED
ON
OFF
- BODY ELECTRICALGARAGE DOOR OPENER SYSTEM
BE-187
2560 Author
: Date
:
2004 LAND CRUISER (RM1071U)
New code registration timing chart
If a code can not be registered, observe the following condi-
tions.
HINT:

If the battery of original transmitter is consumed.

Press the switch of the transmitter repeatedly in registra-
tion mode, as some transmitters stop transmitting for 1 to
2 seconds.

This system is not applicable to the garage door opener
which had been made before 1982.
2. CODE DELETION
(a) Press the switches at both ends of garage door opener
simultaneously for 20 seconds.
HINT:
When transferring to deletion mode, LED (red) blinks in 6 Hz
cycle.
(b) When releasing the switch within 10 seconds after trans-
ferring to deletion mode, all the registered codes will be
erased.
HINT:
Press the switch until blinking in 6 Hz cycle stops, so that the
default code for check is set.

I03488
LED
OPERATION GARAGE DOOR
OPENER SWITCH
(Switch at either end)
ON
OFF CLEAR/DEFAULT
MODEPRESSED
LOAD DEFAULT
LED flashes at a rate of 6 HZ 10 SEC
20 SEC PRESSED
ON
OFFEnter in erase mode to erase all 3 channels BE-188
- BODY ELECTRICALGARAGE DOOR OPENER SYSTEM
2561 Author
: Date
:
2004 LAND CRUISER (RM1071U)
Code deletion timing chart

BE2E5-01
I25537
Connector ºAº
Connector ºBº
To Tail Light
Microphone
Connector ºDº
Garage Door
Opener
Connector ºCºIllumination LED
DOME Fuse
Combination
Switch
TA I L
Relay
Connector ºEº
SW1
SW2
SW3
Circuit
Plate
(Garage
Door
Opener)
Connector ºEºConnector ºFº
Connector ºGº
MIC
AMP
BE-182
- BODY ELECTRICALOVERHEAD JUNCTION BLOCK
2555 Author
: Date
:
2004 LAND CRUISER (RM1071U)
CIRCUIT

BE2E6-01
I24661
Main Circuit Plate
Circuit Plate
(Garage Door Opener Switch)
- BODY ELECTRICALOVERHEAD JUNCTION BLOCK
BE-183
2556 Author
: Date
:
2004 LAND CRUISER (RM1071U)
COMPONENTS

I24662
1 2
34A
Circuit Plate
(Garage Door Opener Switch)Main Circuit Plate
CB
G
E
D
BE-184
- BODY ELECTRICALOVERHEAD JUNCTION BLOCK
2557 Author
: Date
:
2004 LAND CRUISER (RM1071U)Parts No.
Connector nameRelated to systems
A, BVehicle wire harness connector-
COverhead console illumination connector (Unbar)Overhead junction block illumination
DGarage door opener ECU connectorGarage door opener system
EGarage door opener ECU connectorGarage door opener system
GVoice recognition connectorNavigation system
1Garage door opener substrate flat harness connectorGarage door opener system
2Garage door opener switchGarage door opener system
3Garage door opener LED (Green)Garage door opener system
4Garage door opener operate indicator LED (Red)Garage door opener system