. . .
PRECAUTIONS BEFORE SERVICE
2. Sensors, relays, etc., are sensitive to strong impacts.
Handle them with care so that they are not dropped or,
mishandled.
3. The electronic parts used for relays, etc., are sensitive to
heat. If any service which causes a temperature of 80°C
(176’F) or more is performed, remove the part or parts
in question before carrying out the service,
FUSES AND FUSIBLE LINKS
1. If a blown-out fuse is to be replaced, be sure to use only
a fuse of the specified capacity. If a fuse of a capacity
larger than that specified is used, parts may be damaged
and the circuit may not be protected adequately.
2. If additional optional equipment is to be installed in the
vehicle, follow the procedure listed in the appropriate
instruction manual; however, be sure to pay careful
attention to the following points:
(1) In order to avoid overloading the wiring, take the
electrical current load of the optional equipment into
consideration, and determine the appropriate wire
size.
(2) Where possible, route the wiring through the existing
harnesses.
(3) If an ammeter or similar instrument is to be con-
nected to a live-wire circuit, use tape to protect the
wire, use. a clamp to secure the wire, and make sure
that there is no contact with any other parts.
(4) Be sure to provide a fuse for the load circuit of the
optional equipment.
OOY 58E
15A .
OOY 582
Nominal
size
0.3 mm2
0.5 mm2
0.85 mm2
1.25 mm2 2.0
mm2 3.0
mm2
5.0 mm2 SAE
gauge
No.
AWG 22
AWG 20
AWG 18
AWG 16
AWG 14
AWG 12
AWG 10
Permissible current
In engine
compartment
-
7A
9A
12A
16A
21A
31A Other areas
SA
13A
17A
22A
30A
40A
54A 11
