70019401960 Specifications
Section
3 E lectrical System
I
960 1991
Fuse Fed by C ircuit s protecte d Fuse
960 1991
Fuse Fed by Circuit s protected Fuse nurn-rating nurn- r
ating
b er
ber
1 Light
Left
parking lights, 10 A
19 Ignition Control unit, ECC 15
A
switch Licence plate
light switch X Power
mirrors Bulb failure waring
Power seats (controls)
-outer rear lights
Tailgate wash/wipe t---2 Right
parking lights, 10 A Cigar lighter I----Bulb failure
warning 20 Horn 25
A -inner rear lights
Windshield wash/wipe
3 Main
light Left
main beam 15
A Headlight wash /wipe
relay Left auxiliary beam 21 Ignition Automatic pre-heat, diesel 5A r---4 Right
main beam 15 A switch
15 Mode selector I----Right auxiliary beam
22 ABS (control unit)
5
SRS diagnostic socket (Combined instrument not fused) 5A I----
6 Bulb failure Left dipped beam 15
A
warning , Beam length
control, left t---9-pole 7 Right
dipped beam 15
A 23
Control unit, AW 30-43 (A/power) 10 A
Control unit, fuel system Relay,
electric cooling fan
Beam length control, right (B
230/B 280)
8 Light
Foglights front
15 A Diagnostic
socket (B 6304)
r---switch
9 Foglights rear 10 A Indicator light, foglights rear -
24 Battery + Control unit, AW 30-43 10 A
(B/m emory) Control unit , fuel system
10 Lighting : 5A -Instrument panel
- Controls
-
Mode selector
-Beam length control Control
unit
, ignition system t---25 Hazard flash lights 25 A Central locking (Light switch not fused) I-----(Sun roof
26 Clock 10 A
-
ECC controls Courtesy lights
-Radio Door
warning lights
- Clock Engine compartment lighting
-Cigar lighter Trunk lighting
-Ashtray, front and rear -Shift selector scale
- Seat heating -Seat belt locks
I----27 Brake light switch 15
A Bulb failure warning sensor -brake lights P-shift inhibitor (solenoid)
11 Ignition Back-up lights 15 A
switch
151 Turn indicators
Cruise control
I----28 Heater
fan (ECC) 30 A
ECC compr essor t---t---12 Reduced
dip beam (Dim-dip) 15 A
P-shift inhibitor (control circuit) r---
29 Power antenna 30 A
Trailer (Turn indicator switch not fused)
13 Heated
rear window 25 A
Heated mirrors
t---
30 Relay,
fuel Tank pump 10 A
injection Lambda-sond
14 Exhaust
temp. warn. (Japan)
10 A
Overdrive
(M 46, AW 70/71)
Power windows (controls)
31 Battery + Relay, fuel injection 25
A -Fuel pump
Power sun roof
(controls) 32 Battery + Amplifier, radio 15
A
Heated seats (controls) Fasten seat belt reminder
I----33 Radio 10 A
Bulb
failure warning, 14-pole t---15 Reserve t---16 Reserve 3
4
Relay , power Power
windows (motors) 30 A
windows Power
sun roof (motor)
t---35 Heated
seats (power) 30 A
Power seats (motor)
17
Ignition Reserve t---switch X
18 Radio 5A (SRS
Airbag not fused)
136
70019401960 Specifications
Section
4 Power Transmission
Tightening torqu es
Pinion drive flange, pinion with spacer .......... ........ ....... .
pinion with compression
sleeve ' ............ .
Differential bearing caps .............................. ...... . .
Crown
wheel " .. ............................ .......... ...... .
Wheel nuts ...... ............................... .. .......... .
Lock nut -speedometer sensor .
............................. .
• Do not exceed specified torque .. Use new bolts.
I Final drive 760 /780 4-door 1988-, 960
Reduction ratio ................................... .......... .
Axial throw , crown wheel ..................................... .
Backlash ............... .................................... .
Pinion bearing
preload , new .................................. .
old ........ .. ..... .................... .
Differential bearing, preload .................................. .
Clearance , speedometer' -impulse wheel ....... ............... .
Radial throw , outer diameter, impulse wheel ....... ............. .
Lubricant.
..... ............................................. .
T ightening torque s
='.. Coupling flange -pinion (nut) ................................ .
Crown
wheel -differential housing bolt + 60 deg . angle-tightening.
Wheel nuts .. ............................. .................. .
Impulse sender -rear casing (bolt) ............................ .
Rear casing -
final drive (bolt) ................................ .
Side bracket -final drive (bolt) ............................... .
Lock washer -adjustment nut
(bolt) ........................... .
Balance weight -final drive (bolt) ............................. .
Oil drain plug ............................................... .
Oil filler plug ................................................ .
Drive shaft
bolts (+900 angle tightening) ....................... .
Drive shaft nuts,
(+600 angle tightening) ............... ........ .
152
Nm ttlb
200-250 147-185
180-280 130-207
45-60 33-44
90-110 66-81
85 63
25-40 18-29
3.54:1, 3.73:1, 3.91:1
Max 0.08 mm (0.0032 in)
0.1-0. 16 mm (0.04--0 .006 in)
1.2-2.8 Nm (0.87 -2.0 ft Ib)
1.0-2.5 Nm (0.72-1 .8 ft Ib)
1 + 1 notches on each side
0.35-0.75 mm (0.014--0.030 in)
Max.
0.2 mm (0. 008 in)
See page 9
Nm
180-280
35
85
8-12
20-28
40-56
40-56
20-28
27-40
27-40
30
140
ftlb
(133-207)
(26)
(63)
(6-9)
(14--20)
(29-40)
(29-40)
(14--20)
(20-29)
(20-29)
(22)
(103)
